23 September 2022 in Advances in Mechanical Engineering
The inconsistency between continuous feedrate scheduling and discrete interpolation of Non-Uniform Rational B-Splines (NURBS) curves as toolpath interpolation affects the interpolation accuracy and motion smoothness of computer numerical control (CNC) machining. The S-shaped series feedrate scheduling method of the NURBS curve is presented to meet the consistency between feedrate scheduling and interpolation, and the needs of the motor to receive accurate discrete pulses to avoid chatter. The acceleration and deceleration margin factor models are respectively established in the acceleration and deceleration stages to compensate for the velocity loss in the discrete process, so that the feedrate scheduling can be accurately reached in each acceleration and deceleration stage. Based on this, 17 kinds of acceleration and deceleration situations are summarized according to the comparison of displacement, start and end velocity, and the number of interpolation cycles. The butterfly three-segment trajectories are selected for simulation in Matlab. The experimental platform is built based on the Codesys platform programing, and the series feedrate scheduling of the proposed method for a NURBS toolpath is carried out. Both simulations and experiments have verified the effectiveness of the algorithm.
24 July 2024 in Measurement and Control
The motion control library is a standard set of functional blocks integrated in a programmable integration environment, which is of great significance for the rapid development of reconfigurable Programmable Automation Controllers (PAC). However, due to the encapsulation and concealment of function blocks and the incompatibility between software and hardware, the development efficiency of function blocks is low, which is not conducive to the development of autonomous, controllable PAC. Aiming at the above problems, the methods of function block opening and key technology are studied, and a kind of motion control function library architecture and rapid development method based on the PLCopen specification are proposed. A series of motion control function libraries are developed on domestic PLC software. An experimental platform based on domestic hardware and software was designed to verify the typical motion control function library. Experimental results show that this method can effectively shorten the development cycle and that the developed motion control module can meet the actual control needs.