Magnetization, electrical resistivity, magnetoresistance, and Hall resistivity of and Heusler alloys were studied in a temperature range in magnetic fields up to 20 kOe. Both alloys exhibit a martensitic transformation from a high-temperature ferromagnetic austenite phase to a low-temperature, low-magnetization martensitic phase. The electrical resistivity nearly doubles as a result of the martensitic transformation, reaching 180 and 100 µΩ cm in the martensitic states of and , respectively. The temperature dependence of the electrical resistivity does not corresponded with the Mooij correlation. The magnetoresistance is negative with a narrow negative peak at the martensitic transition. Normal and anomalous Hall effect coefficients were determined by fitting the field dependences of the Hall resistivity using magnetization data. The coefficients of the normal Hall effect for both compositions were found to decrease with temperature from positive values in the austenite to negative values in the martensite phase. None of the known correlations between the anomalous Hall effect coefficient and resistivity were satisfied. Significant changes in the values of the anomalous Hall coefficients during the martensitic transformation are explained by the difference in spin-up and spin-down state occupations in the martensite and austenite phases. First-principles calculations of the electronic structures confirm this explanation.
21 October 2008 in Journal of Physics: Condensed Matter
We have studied the structural and magnetic properties of Ni(2)MnGa(1-x)B(x) Heusler alloys with 0≤x≤0.25 using x-ray diffraction, thermal expansion, electrical resistivity, and magnetization measurements. The magnetization measurements were made within the temperature interval of 5-400 K and at applied magnetic field of 0-5 T. The samples with low B concentrations (x<0.05) were found to be of the cubic L2(1) phase at 300 K. A martensitic phase along with the cubic L2(1) phase appears for x≥0.05, and the amount of the martensitic phase was found to increase with increasing x. The critical concentration of the boron substitution (within which Heusler phases exist) was found to be around x = 0.1. The cubic cell parameter was observed to decrease with increasing x in the interval 0≤x≤0.1. The alloys were ferromagnetically ordered at 5 K and the saturation magnetization (M(S)) was found to decrease with increasing boron concentration. The Curie temperatures (T(C)) and martensitic transition temperatures (T(M)) for the alloys with 0≤x≤0.25 have been determined and a phase (T-x) diagram has been constructed. T(M) increases rapidly and T(C) decreases slowly with increasing B concentration in the interval 0≤x≤0.1. The dependence of the phase transition temperatures and magnetization on B concentration is discussed.
In this paper, we have explored the effects of the partial substitution of Ni for a small amount of Co in Ni50Mn35In15 on its structural, magnetic, and electrical properties by using room temperature X-ray diffraction, temperature- and field-dependent magnetization, M(T,H), and resistivity ¿(T,H) measurements in magnetic fields up to 5 T, and in the temperature interval 5-400 K. A small amount of Co (~4%) doping in the Ni site decreases TM and increases TC. For Ni48Co2Mn35In15, a large MR was found to be about -53% at ¿H = 1 T (at T = 275 K) and more than -70% at the same temperature for ¿H = 5 T. The substitution of Co in the Ni position enhances the magnetization jump up to 77 emu/g across the martensitic transformation. Magnetization measurements revealed that the large magnetoresistance value could be due to a metamagnetic-like transition, where the system transforms from a state that contains antiferromagnetically coupled regions to a purely ferromagnetic state. The change in magnetic and electrical properties due to the doping of the Co atom in Ni-Mn-In-based Heusler alloys is discussed in this paper.
Metastable phases were formed in Mn1−xCoxNiGe (x=0.05 and 0.08) by annealing at 800 °C followed by rapid cooling, i.e., quenching, at ambient pressure (P=0) and under a pressure of P=3.5 GPa, and their phase transitions and associated magnetocaloric properties were investigated. The crystal cell volumes of the metastable phases decreased, and their structural transitions significantly shifted to lower temperatures relative to those of the slow-cooled compounds, with a greater reduction observed in the samples where the rapid cooling occurred under high pressures. The magnetic and structural transitions coupled to form a magnetostructural transition in the metastable phases, resulting in large magnetic entropy changes up to −79.6 J kg−1 K−1 (x=0.08) for a 7-T field change. The experimental results demonstrate thermal quenching and high-pressure annealing as alternative methods to create magnetostructural transitions, without modifying the compositions of the materials.
1 February 1995 in Journal of Magnetism and Magnetic Materials
The phase transitions of a series of Co-doped Heusler alloys, Ni2Mn1−xCoxGa (0⩽x⩽0.2), were investigated experimentally using the magnetization measurements, x-ray diffraction, and calorimetric measurements up to their respective melting points. With increasing Co concentration, the structural transition temperatures, Curie temperatures, and melting points, were observed to increase, while the order–disorder transition temperatures decreased. Temperature-dependent x-ray diffraction experiments revealed two different crystal structures in the low-temperature martensite phase for different Co concentrations. However, above their respective structural transitions, both low-temperature crystal structures transformed into the L21 cubic structure. These findings enabled the construction of a complete magnetic and structural phase diagram for Ni2Mn1−xCoxGa, spanning from cryogenic temperatures to the melting points. The temperature-dependent XRD results revealed the abrupt changes in interatomic Mn–Mn distances, which validates the crucial role of Mn–Mn interatomic distance and the effect of the magnetic coupling competition in the structural stability between the martensite phase and austenite phase.