Unlike graphene, the existence of bandgaps (1–2 eV) in the layered semiconductor molybdenum disulphide, combined with mobility enhancement by dielectric engineering, offers an attractive possibility of using single-layer molybdenum disulphide field-effect transistors in low-power switching devices. However, the complicated process of fabricating single-layer molybdenum disulphide with an additional high-k dielectric layer may significantly limit its compatibility with commercial fabrication. Here we show the first comprehensive investigation of process-friendly multilayer molybdenum disulphide field-effect transistors to demonstrate a compelling case for their applications in thin-film transistors. Our multilayer molybdenum disulphide field-effect transistors exhibited high mobilities (>100 cm2 V−1 s−1), near-ideal subthreshold swings (~70 mV per decade) and robust current saturation over a large voltage window. With simulations based on Shockley's long-channel transistor model and calculations of scattering mechanisms, these results provide potentially important implications in the fabrication of high-resolution large-area displays and further scientific investigation of various physical properties expected in other layered semiconductors.
Activating Stubborn Dopants: Many applications of semiconductor light-emitting diodes and lasers, such as reading optical disks, benefit from shorter wavelengths, but this requires materials with larger energy gaps between their valance and conduction bands. The electronic conductivity of these materials often has to be increased by doping with impurity atoms. However, in nitride materials, such as GaN and AlGaN, hole doping with acceptor atoms such as Mg is ineffective at room temperature.
Simon
et al. (p. 60 ) grew a gradient of AlGaN on the surface of GaN and found that the polarization of the layer could field-ionize the acceptor dopants efficiently at room temperature. The heterostructure was used successfully in a light-emitting diode that emits in the ultraviolet.
In this work, fundamental results for carrier statistics in graphene two-dimensional sheets and nanoscale ribbons are derived. Though the behavior of intrinsic carrier densities in two-dimennsional graphene sheets is found to differ drastically from traditional semiconductors, very narrow (sub-10nm) ribbons are found to be similar to traditional narrow-gap semiconductors. The quantum capacitance, an important parameter in the electrostatic design of devices, is derived for both two-dimensional graphene sheets and nanoribbons.
We report the realization of field-effect transistors (FETs) made with chemically synthesized multilayer crystal semiconductor WS2. The Schottky-barrier FETs demonstrate ambipolar behavior and a high (∼105×) on/off current ratio at room temperature with current saturation. The behavior is attributed to the presence of an energy bandgap in the ultrathin layered semiconductor crystal material. The FETs also show clear photo response to visible light. The promising electronic and optical characteristics of the devices combined with the chemical synthesis, and flexibility of layered semiconductor crystals such as WS2 make them attractive for future electronic and optical devices.
The transport properties of carriers in semiconducting graphene nanoribbons are studied by comparing the effects of phonon, impurity, and line-edge roughness scattering. It is found that scattering from impurities located at the surface of nanoribbons and from acoustic phonons are as important as line-edge roughness scattering. The relative importance of these scattering mechanisms varies with the temperature, Fermi-level location, and the width of the ribbons. Based on the analysis, strategies for improvement of low-field mobility are described.
Transport of carriers in two-dimensional graphene at high electric fields is investigated by combining semianalytical and Monte Carlo methods. A semianalytical high-field transport model based on the high rate of optical phonon emission provides useful estimates of the saturation currents in graphene. For developing a more accurate picture, the nonequilibrium (hot) phonon effect and the role of electron-electron scattering were studied using Monte Carlo simulations. Monte Carlo simulations indicate that the hot phonon effect plays a dominant role in current saturation, and electron-electron scattering strongly thermalizes the hot carrier population in graphene. We also find that electron-electron scattering removes negative differential resistance in graphene. Transient phenomenon such as velocity overshoot can be used to speed up graphene-based high-speed electronic devices by shrinking the channel length below 80 nm if electrostatic control can be exercised in the absence of a band gap.