A new kind of double- and single-arm cantilever type DC-contact RF MEMS actuators has been monolithically integrated with an antenna architecture to develop a frequency reconfigurable antenna. The design, microfabrication, and characterization of this ¿reconfigurable antenna (RA) annular slot¿ which was built on a microwave laminate TMM10i ( ¿r = 9.8, tan ¿ = 0.002), are presented in this paper. By activating/deactivating the RF MEMS actuators, which are strategically located within the antenna geometry and microstrip feed line, the operating frequency band is changed. The RA annular slot has two reconfigurable frequencies of operation with center frequencies flow = 2.4 GHz and fhigh = 5.2 GHz, compatible with IEEE 802.11 WLAN standards. The radiation and impedance characteristics of the antenna along with the RF performance of individual actuators are presented and discussed.
Heterojunctions are a well-studied material combination in photocatalysis studies, the majority of which aim to improve the efficacy of the catalysts. Developing novel catalysts begs the question of which photo-generated charge carrier is more efficient in the process of catalysis and the associated mechanism. To address this issue we have fabricated core–shell heterojunction (CSHJ) nanofibers from ZnO and TiO2 in two combinations where only the ‘shell’ part of the heterojunction is exposed to the environment to participate in the photocatalysis. Core and shell structures were fabricated via electrospinning and atomic layer deposition, respectively which were then subjected to calcination. These CSHJs were characterized and studied for photocatalytic activity (PCA). These two combinations expose electrons or holes selectively to the environment. Under suitable illumination of the ZnO–TiO2 CSHJ, e/h pairs are created mainly in TiO2 and the electrons take part in catalysis (i.e. reduce the organic dye) at the conduction band or oxygen vacancy sites of the ‘shell’, while holes migrate to the core of the structure. Conversely, holes take part in catalysis and electrons diffuse to the core in the case of a TiO2–ZnO CSHJ. The results further revealed that the TiO2–ZnO CSHJ shows ∼1.6 times faster PCA when compared to the ZnO–TiO2 CSHJ because of efficient hole capture by oxygen vacancies, and the lower mobility of holes.
8 January 2014 in Journal of Materials Chemistry C
The authors report on the use of hollow cathode plasma for low-temperature plasma-assisted atomic layer deposition (PA-ALD) of crystalline AlN, GaN and AlxGa1−xN thin films with low impurity concentrations.