Robert Chad Gilliam

Robert Chad Gilliam

Auto-generated profile, based on publicly available information

Robert Chad Gilliam

US Environmental Protection Agency

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2010 in Journal of Applied Meteorology and Climatology
Verified
Journal Article
Closed access
RGRobert C. Gilliam
Robert C. Gilliam
JPJonathan E. Pleim
Jonathan E. Pleim
The Pleim–Xiu land surface model, Pleim surface layer scheme, and Asymmetric Convective Model (version 2) are now options in version 3.0 of the Weather Research and Forecasting model (WRF) Advanced Research WRF (ARW) core. These physics parameterizations were developed for the fifth-generation Pennsylvania State University–National Center for Atmospheric Research Mesoscale Model (MM5) and have been used extensively by the air quality modeling community, so there was a need based on several factors to extend these parameterizations to WRF. Simulations executed with the new WRF physics are compared with simulations produced with the MM5 and another WRF configuration with a focus on the replication of near-surface meteorological conditions and key planetary boundary layer features. The new physics in WRF is recommended for retrospective simulations, in particular, those used to drive air quality simulations. In the summer, the error of all variables analyzed was slightly lower across the domain in the WRF simulation that used the new physics than in the similar MM5 configuration. This simulation had an even lower error than the other more common WRF configuration. For the cold season case, the model simulation was not as accurate as the other simulations overall, but did well in terms of lower 2-m temperature error in the western part of the model domain (plains and Rocky Mountains) and most of the Northeast. Both MM5 and the other WRF configuration had lower errors across much of the southern and eastern United States in the winter. The 2-m water vapor mixing ratio and 10-m wind were generally well simulated by the new physics suite in WRF when contrasted with the other simulations and modeling studies. Simulated planetary boundary layer features were compared with both wind profiler and aircraft observations, and the new WRF physics results in a more precise wind and temperature structure not only in the stable boundary layer, but also within most of the convective boundary layer. These results suggest that the WRF performance is now at or above the level of MM5. It is thus recommended to drive future air quality applications.

6 November 2015 in Journal of Geophysical Research: Atmospheres
Verified
Journal Article
Open access
PDF file
RGRobert C. Gilliam
Robert C. Gilliam
CHChristian Hogrefe
Christian Hogrefe
JGJames M. Godowitch
James M. Godowitch
SNSergey Napelenok
Sergey Napelenok
RMRohit Mathur
Rohit Mathur
SRS. Trivikrama Rao
S. Trivikrama Rao
It is well established that there are a number of different classifications and sources of uncertainties in environmental modeling systems. Air quality models rely on two key inputs, namely, meteorology and emissions. When using air quality models for decision making, it is important to understand how uncertainties in these inputs affect the simulated concentrations. Ensembles are one method to explore how uncertainty in meteorology affects air pollution concentrations. Most studies explore this uncertainty by running different meteorological models or the same model with different physics options and in some cases combinations of different meteorological and air quality models. While these have been shown to be useful techniques in some cases, we present a technique that leverages the initial condition perturbations of a weather forecast ensemble, namely, the Short‐Range Ensemble Forecast system to drive the four‐dimensional data assimilation in the Weather Research and Forecasting (WRF)‐Community Multiscale Air Quality (CMAQ) model with a key focus being the response of ozone chemistry and transport. Results confirm that a sizable spread in WRF solutions, including common weather variables of temperature, wind, boundary layer depth, clouds, and radiation, can cause a relatively large range of ozone‐mixing ratios. Pollutant transport can be altered by hundreds of kilometers over several days. Ozone‐mixing ratios of the ensemble can vary as much as 10–20 ppb or 20–30% in areas that typically have higher pollution levels.

9 March 2022 in Journal of Geophysical Research: Atmospheres
Verified
Journal Article
Open access
PDF file
ATAna Torres‐Vazquez
Ana Torres‐Vazquez
JPJonathan Pleim
Jonathan Pleim
RGRobert Gilliam
Robert Gilliam
GPGeorge Pouliot
George Pouliot
The Long Island Sound (LIS) Tropospheric Ozone Study was a multi‐agency collaborative field campaign conducted during the summer of 2018 to improve the understanding of ozone chemistry and transport from New York City to areas downstream, especially the LIS and adjacent Connecticut coastline. Measurements made during this campaign were leveraged to test and evaluate the coupled WRF‐CMAQ model at 12 km, 4 and 1.33 km horizontal grid spacing. Special attention was placed on the model's representation of sea breeze circulations, low level jets, and boundary layer evolution. The evaluation suggests using higher resolutions resulted in improved surface meteorology statistics throughout the whole summer, with temperature biases seeing the biggest statistical improvements when using 1.33‐km grid spacing, going from −0.12 to 0.08 K. Additionally, 4‐km grid spacing provided the biggest advantage when simulating ozone over the region of interest, with biases being reduced from 2.40 to 0.57 to 0.37 ppbV with increased resolution. Case studies of two high ozone concentration events (July 10 and August 6) revealed that sound breezes and low‐level jets had a critical role in transporting pollutant‐rich, shallow marine air masses from the LIS inland over the Connecticut coast. Modifications were made to the representation of sea surface temperatures, which subsequently improved the simulation of surface ozone predictions.

30 January 2020 in npj Climate and Atmospheric Science
Verified
Journal Article
Open access
PDF file
Daiewn  KangDaiewn Kang
Daiewn Kang
RMRohit Mathur
Rohit Mathur
GPGeorge A. Pouliot
George A. Pouliot
RGRobert C. Gilliam
Robert C. Gilliam
DWDavid C. Wong
David C. Wong
Using lightning flash data from the National Lightning Detection Network with an updated lightning nitrogen oxides (NOx) emission estimation algorithm in the Community Multiscale Air Quality (CMAQ) model, we estimate the hourly variations in lightning NOxemissions for the summer of 2011 and simulate its impact on distributions of tropospheric ozone (O3) across the continental United States. We find that typical summer-time lightning activity across the U.S. Mountain West States (MWS) injects NOxemissions comparable to those from anthropogenic sources into the troposphere over the region. Comparison of two model simulation cases with and without lightning NOxemissions show that significant amount of ground-level O3in the MWS during the summer can be attributed to the lightning NOXemissions. The simulated surface-level O3from a model configuration incorporating lightning NOxemissions showed better agreement with the observed values than the model configuration without lightning NOxemissions. The time periods of significant reduction in bias in simulated O3between these two cases strongly correlate with the time periods when lightning activity occurred in the region. The inclusion of lightning NOxincreased daily maximum 8 h O3by up to 17 ppb and improved model performance relative to measured surface O3mixing ratios in the MWS region. Analysis of model results in conjunction with lidar measurements at Boulder, Colorado during July 2014 corroborated similar impacts of lightning NOxemissions on O3air quality. The magnitude of lightning NOxemissions estimated for other summers is comparable to the 2011 estimates suggesting that summertime surface-level O3levels in the MWS region could be significantly influenced by lightning NOx.

12 May 2021 in Journal of Geophysical Research: Atmospheres
Verified
Journal Article
Open access
PDF file
RGRobert C. Gilliam
Robert C. Gilliam
JHJerold A. Herwehe
Jerold A. Herwehe
OBO. Russell Bullock
O. Russell Bullock
JPJonathan Pleim
Jonathan Pleim
LRLimei Ran
Limei Ran
Hosein ForoutanHosein Foroutan
Hosein Foroutan
The U.S. EPA (United States Environmental Protection Agency) is leveraging recent advances in meteorological modeling to construct an air quality modeling system to allow consistency from global to local scales. The Model for Prediction Across Scales‐Atmosphere (MPAS‐A or MPAS) has been developed by the National Center for Atmospheric Research (NCAR) as a global complement to the Weather Research and Forecasting model (WRF). Patterned after a regional coupled system with WRF, the Community Multiscale Air Quality (CMAQ) modeling system has been coupled within MPAS to explore global‐to‐local chemical transport modeling. Several options were implemented into MPAS for retrospective applications. Nudging‐based data assimilation was added to support continuous simulations of past weather to minimize error growth that exists with a weather forecast configuration. The Pleim‐Xiu land‐surface model, the Asymmetric Convective Model 2 boundary layer scheme, and the Pleim surface layer scheme were added as the preferred options for retrospective air quality applications with WRF. Annual simulations were conducted using this EPA‐enhanced MPAS configuration on two different mesh structures and compared against WRF. MPAS generally compares well with WRF over the conterminous United States. Errors in MPAS surface meteorology are comparable to WRF throughout the year. Precipitation statistics indicate MPAS performs slightly better than WRF. Solar radiation in MPAS is higher than WRF and measurements, suggesting fewer clouds in MPAS than WRF. Upper‐air meteorology is well‐simulated by MPAS, but errors are slightly higher than WRF. These comparisons lend confidence to use MPAS for retrospective air quality modeling and suggest ways it can be further improved in the future.

28 January 2025 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
NBNatalie Brett
Natalie Brett
KLKathy S. Law
Kathy S. Law
SASteve R. Arnold
Steve R. Arnold
JFJavier G. Fochesatto
Javier G. Fochesatto
Jean-Christophe RautJean-Christophe Raut
Jean-Christophe Raut
EREllis S. Robinson
Ellis S. Robinson
Lagrangian tracer simulations are deployed to investigate processes influencing vertical and horizontal dispersion of anthropogenic pollution in Fairbanks, Alaska, during the Alaskan Layered Pollution and Chemical Analysis (ALPACA) 2022 field campaign. Simulated concentrations of carbon monoxide (CO), sulfur dioxide (SO2), and nitrogen oxides (NOx), including surface and elevated sources, are the highest at the surface under very cold stable conditions. Pollution enhancements above the surface (50–300 m) are mainly attributed to elevated power plant emissions. Both surface and elevated sources contribute to Fairbanks' regional pollution that is transported downwind, primarily to the south-west, and may contribute to wintertime Arctic haze. Inclusion of a novel power plant plume rise treatment that considers the presence of surface and elevated temperature inversion layers leads to improved agreement with observed CO and NOx plumes, with discrepancies attributed to, for example, displacement of plumes by modelled winds. At the surface, model results show that observed CO variability is largely driven by meteorology and, to a lesser extent, by emissions, although simulated tracers are sensitive to modelled vertical dispersion. Modelled underestimation of surface NOx during very cold polluted conditions is considerably improved following the inclusion of substantial increases in diesel vehicle NOx emissions at cold temperatures (e.g. a factor of 6 at −30 °C). In contrast, overestimation of surface SO2 is attributed mainly to model deficiencies in vertical dispersion of elevated (5–18 m) space heating emissions. This study highlights the need for improvements to local wintertime Arctic anthropogenic surface and elevated emissions and improved simulation of Arctic stable boundary layers.