The construction of heterojunctions provides a promising strategy to improve photocatalytic hydrogen evolution. However, how to fabricate a nanoscale TiO2/g-C3N4 heterostructure and hinder the aggregation of bulk g-C3N4 using simple methods remains a challenge. In this work, we use a simple in situ construction method to design a heterojunction model based on molecular self-assembly, which uses a small molecule matrix for self-integration, including coordination donors (AgNO3), inorganic titanium source (Ti(SO4)2) and g-C3N4 precursor (melamine). The self-assembled porous g-C3N4 nanotube can hamper carrier aggregation and it provides numerous catalytic active sites, mainly via the coordination of Ag+ ions. Meanwhile, the TiO2 NPs are easily mineralized on the nanotube template in dispersive distribution to form a heterostructure via an N–Ti bond of protonation, which contributes to shortening the interfacial carrier transport, resulting in enhanced electron-hole pairs separation. Originating from all of the above synergistic effects, the obtained Ag/TiO2/g-C3N4 heterogenous photocatalysts exhibit an enhanced H2 evolution rate with excellent sustainability 20.6-fold-over pure g-C3N4. Our report provides a feasible and simple strategy to fabricate a nanoscale heterojunction incorporating g-C3N4, and has great potential in environmental protection and water splitting.
The construction of low-cost, high-performance electrocatalysts instead of platinum catalysts is critical to solving the energy crisis. Here, using simple electrospinning and hydrothermal methods, new MoS 2 nanosheets on SrTiO 3 nanofibers (NFs) and 2D SrTiO 3 @MoS 2 heterostructure NFs are synthesized. In addition, SrTiO 3 @MoS 2 heterostructure NFs are compared with bare SrTiO 3 NFs and MoS 2 nanosheets. Importantly, the prepared SrTiO 3 @MoS 2 heterostructure shows better hydrogen-evolution reaction performance than other MoS 2 -based electrocatalysts with an overpotential of 165 mV at 10 mA cm −2 , a Tafel slope of 81.41 mV dec −1 , and long-term electrochemical durability of 3000 cycles. Therefore, the present work strongly demonstrates the positive synergy between SrTiO 3 NFs and layered MoS 2 , and also provides a strategy for preparing low-cost and high-activity water-decomposition electrocatalysts.
Gold nanoparticles (AuNPs) have attracted widespread attention for their excellent catalytic activity, as well as their unusual physical and chemical properties. The main challenges come from the agglomeration and time-consuming separation of gold nanoparticles, which have greatly baffled the development and application in liquid phase selective reduction. To solve these problems, we propose the preparation of polyvinyl alcohol(PVA)/poly(acrylic acid)(PAA)/Fe3O4 nanocomposites with loaded AuNPs. The obtained PVA/PAA/Fe3O4 composite membrane by electrospinning demonstrated high structural stability, a large specific surface area, and more active sites, which is conducive to promoting good dispersion of AuNPs on membrane surfaces. The subsequently prepared PVA/PAA/Fe3O4@AuNPs nanocomposites exhibited satisfactory nanostructures, robust thermal stability, and a favorable magnetic response for recycling. In addition, the PVA/PAA/Fe3O4@AuNPs nanocomposites showed a remarkable catalytic capacity in the catalytic reduction of p-nitrophenol and 2-nitroaniline solutions. In addition, the regeneration studies toward p-nitrophenol for different consecutive cycles demonstrate that the as-prepared PVA/PAA/Fe3O4@AuNPs nanocomposites have outstanding stability and recycling in catalytic reduction.
With development of the society, the problem of environmental pollution is becoming more and more serious. There is the urgent need to develop a new type of sustainable green material for degradable pollutants. However, the conventional preparation method is limited by conditions such as cumbersome operation, high energy consumption, and high pollution. Here, a simple method named self-reduction has been proposed, to synthesize highly efficient catalytic nitro compounds and morin self-assembled MXene-Pd nanocomposites. Palladium nanoparticles were grown in situ on MXene nanosheets to form MXene@PdNPs. MXene@PdNPs composites with different reaction times were prepared by adjusting the reduction reaction time. In particular, MXene@PdNPs20 exhibited a high catalytic effect on 4-NP and 2-NA, and the first-order rate constants of the catalysis were 0.180 s−1 and 0.089 s−1, respectively. It should be noted that after eight consecutive catalytic cycles, the conversion to catalyze 4-NP was still greater than 94%, and the conversion to catalyze 2-NA was still greater than 91.8%. Therefore, the research of self-assembled MXene@PdNPs nanocomposites has important potential value for environmental management and sustainable development of human health, and provides new clues for the future research of MXene-based new catalyst materials.
1 September 2020 in International Journal of Hydrogen Energy
SiO 2 nanowire arrays were synthesized using an AAO template-assisted sol–gel method. As a lithium negative electrode material, the sample exhibited excellent electrochemical properties.