Zhour Hattab

Zhour Hattab

Auto-generated profile, based on publicly available information

Zhour Hattab

Laboratory of Water Treatment and Valorization of Industrial Wastes Department of Chemistry Faculty of Sciences Badji‐Mokhtar University Annaba Algeria

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 November 2022 in Water
Verified
Journal Article
Open access
PDF file
YBYassira Boutaleb
Yassira Boutaleb
RZRadia Zerdoum
Radia Zerdoum
NBNadia Bensid
Nadia Bensid
RARasha AbedRabbuh Abumousa
Rasha AbedRabbuh Abumousa
ZHZhour Hattab
Zhour Hattab
MBMohamed Bououdina
Mohamed Bououdina
This study aims to eliminate hexavalent chromium Cr(VI) ions from water using pomegranate peel (PGP) powder. Dynamic measurements are carried out to examine the influence of the operating factors on the adsorption efficiency and kinetics. The analyzed PGP is found to be amorphous with relatively high stability, contains hydroxyl and carboxyl functional groups, a pH of zero charge of 3.9, and a specific surface-area of 40.38 m2/g. Adsorption tests indicate that PGP exhibits excellent removal effectiveness for Cr(VI) reaching 50.32 mg/g while the adsorption process obeys the Freundlich model. The thermodynamic study favors the exothermic physical adsorption process. The influence of operating parameters like the flow rate (1 to 3 mL/min), bed height (25 to 75 mm), concentration (10 to 30 mg/L), and temperature (298 to 318 K) on the adsorption process are investigated in column mode. To assess the performance characteristics of the column adsorption data, a non-linear regression has been used to fit and analyze four different kinetic and theoretical models, namely, Bohart-Adams, Thomas model, Clark, and Dose response. The obtained experimental results were found to obey the Dose Response model with a coefficient of regression R2 greater than 0.977. This study proved the excellent efficiency in the treatment of chemical industry effluents by using cost-effect abundant biowaste sorbent. This research demonstrated great efficacy in the treatment of chemical industrial effluents by using an abundant, cost-effective biowaste sorbent, thereby achieving the UN SDGs (UN Sustainable Development Goals) primary objective.

12 December 2018 in Bulletin of Chemical Reaction Engineering & Catalysis
Verified
Journal Article
Open access
PDF file
MAMoumen Abdelhak
Moumen Abdelhak
ZHZhour Hattab
Zhour Hattab
YBYoughourta Belhocine
Youghourta Belhocine
KGKamel Guerfi
Kamel Guerfi
NRNacer Rebbani
Nacer Rebbani
In this work, a non-toxic protonated kaolin clay exchanged with protons, was successfully applied as a solid acid catalyst for the polymerization of tetrahydrofuran (poly(THF)) at room temperature in the presence of acetic anhydride. Prior to using the kaolin as a catalyst, it was treated with HCl (0.1 M) and characterized using various analytical techniques. The amounts of catalyst and reaction time on the conversion of THF were investigated. Characterizations of nuclear magnetic Resonance of proton (1H-NMR), Fourier Transform Infrared spectroscopy (FT-IR), X-ray Diffraction (XRD), Optical Microscopy (OM), and Differential Scanning Calorimetry (DSC) techniques were used to examine the resulting polymer. X-ray characterization and DSC data indicated that the obtained poly(THF) is a highly crystalline substance. The results showed that protonated kaolin (kaolin–H+) has a high catalytic activity for the polymerization of THF with a conversion rate of 50.02% after 20 hours.

14 September 2015 in Journal of Water Reuse and Desalination
Verified
Journal Article
Closed access
PDF file
RMRadia Mazouz
Radia Mazouz
NFNaima Filali
Naima Filali
ZHZhour Hattab
Zhour Hattab
KGKamel Guerfi
Kamel Guerfi
A continuous adsorption study in a fixed-bed column was carried out by using the granulated slag as an adsorbent for the removal of methylene blue (MB) from aqueous solution. Effects of various parameters, such as initial dye concentration, flow rate, bed depth, and pH were investigated. Obtained results confirmed that the breakthrough time and exhaustion time were dependent on these factors. The adsorption capacity of GS was calculated at 50% breakthrough point for different conditions. The highest breakthrough capacity (q,exp = 0.296 mg.g–1) was obtained with a 15 cm bed height and a 2 mL.min–1 rate by using 10 mg.L–1 initial MB concentration at pH 7.5. Bohart–Adams, Bed Depth Service Time (BDST), and Thomas models were applied to experimental data to determine the characteristic parameters of the column. The Thomas model was found suitable for the description of whole breakthrough curve, while the Bohart–Adams model was only used to predict the initial part of the dynamic process. The data were in good agreement with the BDST model. Thus, the granulated slag can be used as an adsorbent in the treatment of wastewater. Desorption was carried out with a deionized water as desorbing agent and reuse study was investigated.

1 February 2018 in Sensor Letters
Verified
Journal Article
Closed access
WBWahiba Bessashia
Wahiba Bessashia
ZHZhour Hattab
Zhour Hattab
YBYamina Berredjem
Yamina Berredjem
Ridha DjellabiRidha Djellabi
Ridha Djellabi
RZRadia Zerdoum
Radia Zerdoum
KGKamel Guerfi
Kamel Guerfi
Biomass wastes are being recognized as emerging functional platforms that can be utilized in various fields. Eggshell, which can be found everywhere due to the large eggs consumption, has usually been regarded as waste and overlooked. In this contribution, we report the use of three powders prepared from eggshell waste such as Eggshell without membrane (ES), Eggshell membrane (ESM) and Eggshell with membrane (ESM-ES) as biosorbents for the removal of Rhodamine B (RhB) from water. Biosorbent powders were characterized by XRD, SEM, BET and FTIR. The effects of initial RhB concentration, temperature and pH on dye adsorption were performed. The results showed that the ESM, due to its 3D network porous structure, exhibited the highest adsorption efficiency than ES and ES-ESM. The RhB sorption on these adsorbents obeys pseudo-second-order kinetics which indicates a chemisorption process. For ESM adsorbent, the Freundlich isotherm model has a best-fit compared to Langmuir and Temkin isotherm models (multilayer dye adsorption with non-uniform distribution). However, for ES and ESM-ES adsorbents Langmuir has a best-fit than the other models (monolayer dye adsorption).

1 June 2017 in Desalination and Water Treatment
Verified
Journal Article
Open access
RZRadia Zerdoum
Radia Zerdoum
ZHZhour Hattab
Zhour Hattab
YBYamina Berredjem
Yamina Berredjem
RMRadia Mazouz
Radia Mazouz
Ridha DjellabiRidha Djellabi
Ridha Djellabi
KGKamel Guerfi
Kamel Guerfi

1 November 2018 in Desalination and Water Treatment
Verified
Journal Article
Open access
AAAssia Allaoui
Assia Allaoui
ZHZhour Hattab
Zhour Hattab
RZRadia Zerdoum
Radia Zerdoum
Ridha DjellabiRidha Djellabi
Ridha Djellabi
YBYamina Berredjem
Yamina Berredjem
KGKamel Guerfi
Kamel Guerfi