20 November 2021 in Industrial & Engineering Chemistry Research
An electroassisted filtration technique has been employed to improve dewatering of a suspension of microfibrillated cellulose (MFC) produced via 2,2,6,6-tetramethylpiperidinyl-1-oxyl (TEMPO)-mediated oxidation. In addition, all-atom molecular dynamic (MD) simulations were performed to deepen the understanding of the complicated dewatering mechanism on a molecular level. Both the experimental and the simulation results implied that the dewatering rate was not only improved when electroassisted filtration was used but also found to be proportional to the strength of the electric field. A channeled dewatered structure was observed for these experiments and may have contributed to enhanced dewatering by providing high overall permeability. The MD simulations revealed that the electric field had a significant impact on the fibril movement, whereas the impact of pressure was limited. The simulations also suggested that the increased filtrate flow upon the application of an electric field was not only due to electroosmotic flow but also due to electrophoretic movement of the fibrils toward the anode that led to the release of water that had been trapped between the fibrils, allowing it to be pressed out together with the rest of the bulk water. This study shows that electroassisted filtration has the potential to improve the dewatering of TEMPO-MFC, and the MD simulations provide further insights into the dewatering mechanism.
24 January 2023 in Physical Chemistry Chemical Physics
Capillary forces between cellulose channels depend on the direction and magnitude of an applied electric field. An electric field applied parallel to a solid–liquid interface increases the capillary force while a perpendicular field reduces it.
25 September 2023 in Cellulose
Efficient dewatering is necessary to achieve an economically sustainable large-scale production of microfibrillated cellulose (MFC) because the low solids content of the final product (< 3 wt.%) results in high costs related to transportation and storage, and problems for products with water incompatibility. Mechanical dewatering is preferred to thermal drying due to its lower energy demand, but MFC has a very high filtration resistance, which implies that an excessive filter area is necessary. Thus, to improve the dewatering, electro-assisted filtration may be used. In this study a bench-scale dead-end filter press was modified and the electro-assisted filtration of MFC, with two degrees of fibrillation, was investigated. The impact of the degree of fibrillation was clear when either pressure or electric field were applied separately. It was more challenging to dewater MFC with a higher degree of fibrillation using conventional filtration due to a greater surface area being subjected to the liquid flow. The opposite was found when using an electric field alone: the more fibrillated material has a higher surface charge and thereby is impacted more by the electric field. A combination of pressure and electric field resulted in a greatly improved dewatering rate, but no significant difference could be observed between the two qualities. After dewatering, the water retention value was slightly decreased, but the material still showed a gel-like behaviour, although the network strength was slightly reduced, as seen by a reduction in yield stress, storage and loss moduli. This was plausibly due to a decrease in the surface area and/or deformed network.
12 October 2022 in Industrial & Engineering Chemistry Research