Nenad Novkovski

Nenad Novkovski

Auto-generated profile, based on publicly available information

Nenad Novkovski

Ss. Cyril and Methodius University in Skopje

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 March 2006 in Applied Physics A
Verified
Journal Article
Closed access
PDF file
NNN. Novkovski
N. Novkovski
EAE. Atanassova
E. Atanassova

27 May 2025
Verified
Book Chapter
Closed access
PDF file
VSVlado Spiridonov
Vlado Spiridonov
MĆMladjen Ćurić
Mladjen Ćurić
NNNenad Novkovski
Nenad Novkovski

Verified
Journal Article
Open access
PDF file
AIAleksandra Ivanoska-Dacikj
Aleksandra Ivanoska-Dacikj
Petre MakreskiPetre Makreski
Petre Makreski
NGNikola Geskovski
Nikola Geskovski
JKJoanna Karbowniczek
Joanna Karbowniczek
Urszula StachewiczUrszula Stachewicz
Urszula Stachewicz
GBGordana Bogoeva-Gaceva
Gordana Bogoeva-Gaceva
Reduced graphene oxide (rGO) is one of the graphene derivatives that can be employed to engineer bioactive and/or electroactive scaffolds. However, the influence of its low and especially high concentrations on scaffolds’ overall properties and cytotoxicity has yet to be explored. In this study, polyethylene oxide (PEO)-based scaffolds containing from 0.1 to 20 wt% rGO were obtained by electrospinning. Morphological, thermal and electrical properties of the scaffolds were characterized by SEM, Raman spectroscopy, XRD, DSC and electrical measurements. The diameter of the fibers decreased from 0.52 to 0.19 µm as the concentration of rGO increased from 0.1 wt% to 20 wt%. The presence of rGO above the percolation threshold (5.7 wt%) resulted in a significantly reduced electrical resistivity of the scaffolds. XRD and Raman analysis revealed delamination of the graphene layers (interlayer spacing increased from 0.36 nm to 0.40–0.41 nm), and exfoliation of rGO was detected for the samples with an rGO concentration lower than 1 wt%. In addition, an evident trend of increasing cell viability as a function of the rGO concentration was evidenced. The obtained results can serve as further guidance for the judicious selection of the rGO content incorporated into the PEO matrix for constructing electroactive scaffolds.

1 October 2017 in Journal of Physics Communications
Verified
Journal Article
Open access
PDF file
NNNenad Novkovski
Nenad Novkovski
In this work a modification of Terman method for determination of interfacial energy states located in the forbidden energy gap of the semiconductor (interface states) convenient for application in metal-high-κ-Si structures is proposed and explained in details. It has been found that usually observed presence of tails in the distribution of interface states towards the band edges is an artifact due to the method of determination of interface state densities. While excluding the contribution of quantum charge in semiconductor close to the interface with dielectric, these tails in the distribution disappear. Simple efficient method for determination of total density of interface states over the silicon bandgap is proposed.

11 October 2004 in Applied Physics Letters
Verified
Journal Article
Closed access
NNN. Novkovski
N. Novkovski
EAE. Atanassova
E. Atanassova
In this paper a compact model for leakage currents of metal∕Ta2O5∕SiO2∕Si structures is presented, considering tunneling and hopping conduction in a SiO2 layer and Poole-Frenkel emission in a Ta2O5 layer. Theoretical calculations fit very well the experimental results obtained on thermally grown Ta2O5 films over an unintentionally grown ultrathin SiO2 layer for both bias polarities. The following parameters were fitted: the SiO2 layer thickness, the hopping conductivity of a SiO2 layer, and the Poole-Frenkel defect-related constant. Experimentally observed asymmetry between different polarities was explained by the injection of holes from the silicon substrate at negative bias.

28 May 2017 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
NNNenad Novkovski
Nenad Novkovski
EAElena Atanassova
Elena Atanassova
Capacitance of metal–insulator–Si structures containing high permittivity dielectric exhibits complicated behaviour when voltage and frequency dependencies are studied. From our study on metal (Al, Au, W)–Ta2O5/SiO2–Si structures, we identify serial C-R measurement mode to be more convenient for use than the parallel one usually used in characterization of similar structures. Strong frequency dependence that is not due to real variations in the dielectric permittivity of the layers is observed. Very high capacitance at low frequencies is due to the leakage in Ta2O5 layer. We found that the above observation is mainly due to different leakage current mechanisms in the two different layers composing the stack. The effect is highly dependent on the applied voltage, since the leakage currents are strongly nonlinear functions of the electric field in the layers. Additionally, at low frequencies, transition currents influence the measured value of the capacitance. From the capacitance measurements several parameters are extracted, such as capacitance in accumulation, effective dielectric constant, and oxide charges. Extracting parameters of the studied structures by standard methods in the case of high-κ/interfacial layer stacks can lead to substantial errors. Some cases demonstrating these deficiencies of the methods are presented and solutions for obtaining better results are proposed.