1 December 2024 in Acta crystallographica Section B, Structural science, crystal engineering and materials
A seventh blind test of crystal structure prediction was organized by the Cambridge Crystallographic Data Centre featuring seven target systems of varying complexity: a silicon and iodine-containing molecule, a copper coordination complex, a near-rigid molecule, a cocrystal, a polymorphic small agrochemical, a highly flexible polymorphic drug candidate, and a polymorphic morpholine salt. In this first of two parts focusing on structure generation methods, many crystal structure prediction (CSP) methods performed well for the small but flexible agrochemical compound, successfully reproducing the experimentally observed crystal structures, while few groups were successful for the systems of higher complexity. A powder X-ray diffraction (PXRD) assisted exercise demonstrated the use of CSP in successfully determining a crystal structure from a low-quality PXRD pattern. The use of CSP in the prediction of likely cocrystal stoichiometry was also explored, demonstrating multiple possible approaches. Crystallographic disorder emerged as an important theme throughout the test as both a challenge for analysis and a major achievement where two groups blindly predicted the existence of disorder for the first time. Additionally, large-scale comparisons of the sets of predicted crystal structures also showed that some methods yield sets that largely contain the same crystal structures.
17 October 2024 in Acta crystallographica Section B, Structural science, crystal engineering and materials
A seventh blind test of crystal structure prediction has been organized by the Cambridge Crystallographic Data Centre. The results are presented in two parts, with this second part focusing on methods for ranking crystal structures in order of stability. The exercise involved standardized sets of structures seeded from a range of structure generation methods. Participants from 22 groups applied several periodic DFT-D methods, machine learned potentials, force fields derived from empirical data or quantum chemical calculations, and various combinations of the above. In addition, one non-energy-based scoring function was used. Results showed that periodic DFT-D methods overall agreed with experimental data within expected error margins, while one machine learned model, applying system-specific AIMnet potentials, agreed with experiment in many cases demonstrating promise as an efficient alternative to DFT-based methods. For target XXXII, a consensus was reached across periodic DFT methods, with consistently high predicted energies of experimental forms relative to the global minimum (above 4 kJ mol−1 at both low and ambient temperatures) suggesting a more stable polymorph is likely not yet observed. The calculation of free energies at ambient temperatures offered improvement of predictions only in some cases (for targets XXVII and XXXI). Several avenues for future research have been suggested, highlighting the need for greater efficiency considering the vast amounts of resources utilized in many cases.
26 March 2019 in The Journal of Chemical Physics
Five paradigmatic polycyclic aromatic hydrocarbons (PAHs) (pyrene, circum-1-pyrene, coronene, circum-1-coronene, and circum-2-coronene) are used for studying the performance of three single-reference methods {scaled opposite-spin-algebraic diagrammatic construction to second-order [SOS-ADC(2)], time-dependent (TD)-B3LYP, and TD-Coulomb-attenuating method (CAM)-B3LYP} and three multireference (MR) methods [density functional theory/multireference configuration interaction (DFT/MRCI), strongly contracted-n-electron valence state perturbation theory to second order (NEVPT2), and spectroscopy oriented configuration interaction (SORCI)]. The performance of these methods was evaluated by comparison of the calculated vertical excitation energies with experiments, where available. DFT/MRCI performs best and thus was used as a benchmark for other approaches where experimental values were not available. Both TD-B3LYP and NEVPT2 agree well with the benchmark data. SORCI performs better for coronene than for pyrene. SOS-ADC(2) does reasonably well in terms of excitation energies for smaller systems, but the error increases somewhat as the size of the system gets bigger. The natural transition orbital analysis for SOS-ADC(2) results indicated that at least two configurations were essential to characterize most of the lower-case electronic states. TD-CAM-B3LYP gives the largest errors for excitation energies and also gives an incorrect order of the lowest two states in circum-1-pyrene. A strong density increase of dark states was observed in the UV spectra with increasing size except for the lowest few states which remained well separated. An extrapolation of the UV spectra to infinite PAH size for S1, S2, and the first bright state based on the coronene series was made. The extrapolated excitation energies closest to experimental measurements on graphene quantum dots were obtained by TD-CAM-B3LYP.
4 March 2019 in Physical Chemistry Chemical Physics
The study of electronically excited states of stacked polycyclic aromatic hydrocarbons (PAHs) is of great interest due to promising applications of these compounds as luminescent carbon nanomaterials such as graphene quantum dots (GQDs) and carbon dots (CDs). In this study, the excited states and excitonic interactions are described in detail based on four CD model dimer systems of pyrene, coronene, circum-1-pyrene and circum-1-coronene. Two multi-reference methods, DFT/MRCI and SC-NEVPT2, and two single-reference methods, ADC(2) and CAM-B3LYP, have been used for excited state calculations. The DFT/MRCI method has been used as a benchmark method to evaluate the performance of the other ones. All methods produce useful lists of excited states. However, an overestimation of excitation energies and an inverted ordering of states, especially concerning the bright HOMO–LUMO excitation, are observed. In the pyrene-based systems, the first bright state appears among the first four states, whereas the number of dark states is significantly larger for the coronene-based systems. Fluorescence emission properties are addressed by means of geometry optimization in the S1 state. The inter sheet distances for the S1 state decrease in comparison to the corresponding ground-state values. These reductions are largest for the pyrene dimer and decrease significantly for the larger dimers. Several minima have been determined on the S1 energy surface for most of the dimers. The largest variability in emission energies is found for the pyrene dimer, whereas in the other cases a more regular behavior of the emission spectra is observed.
3 September 2019 in The Journal of Physical Chemistry Letters