1 May 2020 in Solar Energy
1 December 2020 in Energy Reports
5 July 2025 in Applied Thermal Engineering
3 May 2019 in Key Engineering Materials
In the present study, heat transfer characteristics of MgO-oil based nanofluid in a miniature counter-flow double-pipe heat exchanger are investigated experimentally and numerically. The nanofluid is a mixture of corn oil as a base fluid and MgO particles in nanorange. The heat exchanger is fabricated from 316 stainless steel with length 500 mm. Cold water flows in the annulus side, and the nanofluid is utilized as the hot medium in the inner tube. ANSYS FLUENT 17,0 commercial software was employed for numerical investigation. The results obtained from using nanofluids are compared with the pure oil base fluid as a hot medium. Effects of inlet flow rate of hot nanofluids and concentration of nanoparticles are considered. It is observed that the average heat transfer rates for nanofluids are higher than those for pure corn oil. The improvement of both MgO concentration and inlet flow rates of nanofluid has a positive impact on the overall heat transfer coefficient and heat transfer rate. In contrast, the pumping power augments as well as the pressure drop increases.
1 August 2018 in Materials Science Forum
The prime purpose of the current study was to investigate the consequence of surfactant on the kinematic viscosity, thermal conductivity, and stability of MgO-oil based nanofluid. Magnesia (MgO) nanoparticles were prepared by the wet chemical method. Structural and morphological analysis of synthesized nanoparticles were performed via X-ray diffraction (XRD) and Transmission electron microscope (TEM). Subsequently, nanofluid was prepared at a solid concentration of 0.025% in presence of various surfactants with the aid of ultrasonic technique. The impact of the different surfactants (Cetyl Trimethyl Ammonium Bromide (CTAB), Poly Vinyl Pyrrolidone (PVP), Poly Vinyl Alcohol (PVA), and Oleic Acid) on the nanofluid stability was tested. It was evident that CTAB and PVA surfactants establish the most stable prepared MgO-oil based nanofluid. The experiments revealed that the maximum UV–Vis absorbance of the solution corresponds to the dispersion of CTAB in the base fluid.
27 September 2025 in Applied Thermal Engineering