22 April 2019 in Applied Physics Letters
This work demonstrates the construction of p-n heterojunctions between mechanically exfoliated beta-phase gallium oxide (β-Ga2O3) and p-GaN. The detailed mechanical exfoliation process was developed and can be used for further device applications. The atomic force microscopy study showed that the exfoliated β-Ga2O3 flakes had a very smooth surface with a roughness of 0.65 nm. Transmission electron microscopy revealed a clearly defined interface between the exfoliated β-Ga2O3 and p-GaN. The p-n heterojunction exhibited a turn-on voltage of 3.6 V and a rectification ratio of ∼105. The heterojunction also showed good thermal performance up to 200 °C. Ideality factors and turn-on voltages decrease with temperature, tending toward the ideal threshold voltage of 3.2 V as determined by Silvaco simulations. This work provides valuable information on a mechanically exfoliated β-Ga2O3/GaN p-n heterojunction, which opens up the opportunities for a variety of photonic and electronic applications.
3 December 2018 in Applied Physics Letters
SAShanthan Reddy Alugubelli
Shanthan Reddy Alugubelli
+5
To mimic selective-area doping, p-GaN was regrown on an etched GaN surface on GaN substrates by metalorganic chemical vapor deposition. Vertical GaN-on-GaN p-n diodes were fabricated to investigate the effects of the etch-then-regrowth process on device performance. The crystal quality of the sample after each epitaxial step was characterized by X-ray diffraction, where the etch-then-regrowth process led to a very slight increase in edge dislocations. A regrowth interfacial layer was clearly shown by transmission electron microscopy. Strong electroluminescence was observed with three emission peaks at 2.2 eV, 2.8 eV, and 3.0 eV. The forward current density increased slightly with increasing temperature, while the reverse current density was almost temperature independent indicating tunneling as the reverse transport mechanism. This result is very similar to the reported Zener tunnel diode comprising a high doping profile at the junction interface. High levels of silicon and oxygen concentrations were observed at the regrowth interface with a distribution width of ∼100 nm. This work provides valuable information on p-GaN regrowth and regrown GaN p-n diodes, which can serve as an important reference for developing selective doping for advanced GaN power electronics for high voltage and high power applications.
24 June 2021 in IEEE Electron Device Letters
We report enhancement-mode p-channel heterojunction field-effect transistors (HFETs) without gate recess on a standard p-GaN/AlGaN/GaN high electron mobility transistor (HEMT) platform. The p-GaN in the gate region was partially passivated by a low-power hydrogen plasma treatment process, and the remaining active p-GaN and the underlying AlGaN formed the p-channel. The device showed a record low off-state leakage of <; 10 -8 A/mm and subthreshold swing (SS) of 123.0 mV/dec with a threshold voltage ( V th ) of -0.6 V and high-temperature stability up to 200 °C. These results indicate that the hydrogen plasma treatment is beneficial for suppressing leakages and preserving excellent material quality in the p-channel. With the success of the p-HFETs, the p-GaN/AlGaN/GaN platform can enable the monolithic integration of GaN n- and p-channel transistors without the need for regrowth. This work represents a significant step towards the implementation of the GaN CMOS technology.
5 August 2020 in IEEE Transactions on Electron Devices
We report an experimental demonstration of GaN-based vertical-channel junction field-effect transistors (VC-JFETs). A p-GaN regrowth by metalorganic chemical vapor deposition (MOCVD) and a subsequent self-planarization process were developed to fabricate the GaN VC-JFETs. Fin-like channel regions were patterned by electron beam lithography (EBL) and aligned to ${m}$ -plane or ${a}$ -plane. The electrical properties of lateral and vertical p-n junctions were characterized to verify the effectiveness of the p-GaN regrowth. Both VC-JFETs with ${m}$ -plane and ${a}$ -plane channels show decent gate modulation. We further discussed important factors that may affect the device performance including interfacial impurities and nonuniform acceptor distribution. This work highlights the successful demonstration of GaN VC-JFETs and lateral p-n junctions by an etch-then-regrow process, providing valuable information and reference for the further development of GaN power electronics.
23 November 2020 in Journal of Applied Physics
This work reports on a comprehensive examination of the electrical and thermal properties of vertical Schottky diodes fabricated on - and (001)-oriented samples of β-Ga2O3. The temperature-dependent current–voltage (I–V) and capacitance–voltage (C–V) data were gathered and analyzed down to 60 K. Deep level transient spectroscopy (DLTS) was used to study bulk and interface defects in the two materials from approx. 325 K down to 60 K. In the bulk material, an electron trap was observed at EC−0.46 eV, with a capture cross section of 1.6 × 10−14 cm2 and a lambda-corrected maximum trap density of 9.08 × 1015 cm−3. These results and others indicate that the electron trap is a strong candidate for the well-known E1 defect in β-Ga2O3 based on recent investigations. Additionally, in the material, the smooth modulation typical of interface states is evident at temperatures below 275 K. The (001) samples manifested what is likely the E2* electron trap at EC−0.68 eV, with a capture cross section of 1.64 × 10−15 cm2 and a lambda-corrected maximum trap density of 8.85 × 1015 cm−3. The presence of the E2* defect, in particular, is a contrast to the findings of recent DLTS investigations on β-Ga2O3, which report that E2* emerged only after low-energy proton irradiation. These results help to further map out the defect signatures found in β-Ga2O3 materials, which are of vital importance in the design and fabrication of future β-Ga2O3 devices.
4 August 2020 in IEEE Journal of the Electron Devices Society
Vertical GaN Schottky barrier diodes (SBDs) with floating metal rings (FMRs) as edge termination structures have been fabricated on bulk GaN substrates. Devices with different FMR geometries were investigated including various numbers of rings and various spacings between rings. These devices have a low Ron of 1.16 1.59 mΩ.cm2, a turn-on voltage of 0.96 0.94 V, a high on-off ratio of 109, a nearly ideal ideality factor of 1.03 1.09, and a Schottky barrier height of 1.11 1.18 eV at room temperature. These devices have similar forward electrical characteristics, indicating that FMRs don’t degrade the device rectifying performance. The ideality factor decreased and the Schottky barrier height increased with increasing temperature from 300 K to 420 K, where the temperature dependencies of the two parameters indicate the inhomogeneity of the metal/semiconductor Schottky interface. In addition, FMRs can improve device breakdown voltages. As the number of FMRs increased from 0 to 20, the reverse breakdown voltage increased from 223 to 289 V. As the spacing between the FMRs increased from 1.5 to 3 μm, the reverse breakdown voltage increased from 233 to 290 V, respectively. These results indicate multiple FMRs with proper spacings can effectively improve breakdown performance without degrading the device forward characteristics. This work represents a useful reference for the FMR termination design for GaN power devices.