Engineered nanomaterials, like graphene with tunable adsorption sites and nanoscale zero-valent iron (nZVI) with unique redox chemistry, offer great prospects for removing pharmaceutical and personal care products (PPCPs) through adsorption and catalytic advanced oxidation processes (AOPs) in comparison to bulk materials. Although PPCPs are found as a complex mixture in wastewater and in the environment, most studies regarding nano-enabled PPCP removal reported results with only one PPCP at a time and typically at high initial concentrations. In this study, we utilized reduced graphene oxide (rGO) as a support for nZVI to synthesize rGO–nZVI nanohybrids (NHs) and used rGO–nZVI NHs for the removal of a complex mixture of 12 diverse PPCPs that includes antibiotic, anti-inflammatory, anti-seizure, and antidepressant pharmaceuticals, which are recalcitrant in the environment. We also tested the removal of PPCPs at their individual environmentally relevant concentrations at the ppb level. The rGO–nZVI NH was synergistically utilized as both an adsorbent and a heterogeneous Fenton catalyst (for AOPs) in the presence of H2O2 to remove ∼95–99% of environmentally relevant concentrations (200 ppb) of PPCPs within 10 minutes. Even in the absence of H2O2, the hybridization resulted in better adsorptive properties (14–72% more removal) of the rGO–nZVI NHs compared to the parent nanomaterials (rGO or nZVI) for various PPCPs in the mixture, removing ∼82–99% of PPCPs, at the end of 30 minutes, with comparatively slower kinetics (∼3–5.5 times) than in the presence of H2O2. Hydrophobic PPCPs were removed faster and more PPCPs were removed by both adsorption and AOPs. The potential of utilizing rGO–nZVI NHs in drinking/wastewater treatment systems, or even in point-of-use systems where necessary, was substantiated by the enhanced and fast PPCP removal capacity of nanohybrids.
The photocatalytic degradation of the azo dye tartrazine using zinc oxide (ZnO) as photocatalyst under ultraviolet light was investigated using a 24 factorial design. The variables studied were the aspect ratio of ZnO nanorods, the ZnO load, the initial pH of tartrazine solution, and the H2O2 volume. These variables were studied aiming to maximize the tartrazine removal efficiency and the pseudo-1st-order rate constant of the removal process. The ZnO aspect ratio was tuned by varying the Lewis base during the synthesis, hexamethylenetetramine (HMTA) was used to prepare ZnO with low aspect ratio (ZnO_LowAR), and NaOH was used to prepare ZnO with high aspect ratio (ZnO_HighAR). The microstructural characterizations indicated that ZnO_LowAR and ZnO_HighAR nanorods have similar structural, textural and optical properties. The only exception was the dimensions of the nanorods obtained, which could result in differences in the facets exposed on each type of nanorod surface. The factorial design revealed that ZnO aspect ratio, the initial pH of tartrazine solution, and the H2O2 volume all have primary significant effects, whereas the ZnO load is not significant neither in the tartrazine removal efficiency nor in the pseudo-1st-order rate constant. Statistical models considering the coefficients of the significant interactions were obtained, leading to reasonable predicted results in comparison to the results experimentally obtained. The conditions leading to highest removal efficiency (~92%) and pseudo-1st-order rate constant (3.81 x 10-2 min-1) were carried out with ZnO_HighAR, initial pH 7, and without H2O2, which outperformed the TiO2 P-25 under the same conditions.