Electromagnetic forming is a method of high-speed metal workpiece forming technology that uses electromagnetic force pulses generated from the interaction of the magnetic flux density and workpiece induced eddy current. The main challenge of this technology is the control of the eddy current and magnetic flux density to perform various forming processes. This paper is aimed at overcoming this challenge by introducing a new electromagnetic sheet forming method based on discretely driven rings. In this method, a set of discrete conducting rings are placed between the driving coil and the metal workpiece to enhance the shaping process of the workpiece. By changing the number and position of the rings, the induced eddy current can be adjusted, and different electromagnetic force distribution profiles can be realized. COMSOL software is used to develop an electromagnetic field–structure coupling model of the proposed electromagnetic forming method. The characteristics of the electromagnetic force distribution and its effect on the workpiece forming process are analyzed. Results show that the electromagnetic force distribution profile can be controlled by adjusting the rings physical parameters such as diameter, material, and position. The proposed method can effectively improve the performance of the conventional electromagnetic forming technology and has the potential for implementation in wide industry applications.
Due to the fact that geometrical structure of tube electromagnetic bulging process with field shaper does not conform to the axisymmetric property, three-dimensional (3D) model is usually used to analyze the process which is complicated and time consuming. Therefore, on the basis of understanding the working principle of the field shaper, a two-dimensional (2D) model with current constraint is proposed in this paper to analyze the electromagnetic bulging process of a tube fitted with a field shaper. COMSOL finite element analysis software is used to develop three models for performance analysis and comparison, these are: conventional 3D model and the proposed 2D model with and without current constraint. Simulation results show that the induced eddy current density, magnetic flux density and electromagnetic body density of the two-dimensional model with current constraint are in good agreement with the results of the three-dimensional model. This provides an alternative and effective way to analyze the performance of the tube electromagnetic bulging with field shaper using a simple but yet reliable 2D model.
Uneven axial deformation is the current main issue of the tubes electromagnetic bulging technology which calls for innovative and cost-effective solutions. This paper presents a new method to overcome the above-mentioned issue based on employing a magnetic field shaper. The proposed magnetic field shaper is employed in the middle of the pipe and the driving coil. Induced eddy current control is realized by changing the structural parameters of the magnetic field shaper; thereby regulating the electromagnetic force distribution. The effectiveness of the proposed method is investigated through numerically comparing the electromagnetic performance of two EMF setups; traditional coil-based loading model and magnetic field shaper driving coil-based loading model proposed in this paper. The influence of the magnetic field shaper structural parameters on the tube electromagnetic forming performance is examined for optimum structure design. Results reveal that the concave profile of the radial electromagnetic force in the traditional loading method can be effectively improved using the proposed loading in this paper. The introduction of a magnetic field shaper not only changes the induced eddy current distribution, but also regulates the electromagnetic force profile in the axial-direction of the pipe which effectively enhances the uniform range of the pipe electromagnetic bulging, the maximum uniform deformation area is increased from 9mm to 35mm.
Tube uneven radial deformation along the axial direction is one of the main technical problems of tube electromagnetic bulging, which restricts the wide advancement of this technology. In order to improve the uniformity of tube radial deformation, a tube electromagnetic bulging method based on concave magnetic field shaper is presented in this paper. Based on the theory of tube electromagnetic bulging and magnetic field shaper, an electromagnetic structure coupling finite element model is built using COMSOL commercial software. Obtained results show that the proposed concave magnetic field shaper can alter the magnetic field distribution on the tube to shape the produced electromagnetic force in a concave profile so that the tube can exhibit more uniform bulging effect. In the case study investigated in this paper, the maximum uniform region increases from 23.7mm to 56.2mm when the concave magnetic field shaper is used. Obviously, the introduction of concave magnetic field shaper can effectively solve the problem of the tube uneven radial deformation during electromagnetic bulging process, and promote more industrial applications of this technology.