1 March 2019 in Physics of Plasmas
An original electrically small antenna concept relying on plasma discharges is presented in this paper. It consists of a small coaxial probe placed above a ground plane and surrounded by a hemispherical inductively coupled plasma discharge. This plasma discharge behaves as a subwavelength epsilon-negative resonator exhibiting a localized surface plasmon resonance at microwave frequencies with significant radiation efficiency. Measurements show that the plasma allows impedance matching of the radiating element and frequency agility from 310 to 390 MHz by controlling the power delivered to the discharge. Meanwhile, significant radiation enhancement up to 20 dB at 300 MHz is measured. The existence of the localized surface plasmon resonance is finally confirmed by a Mie analysis considering the measured plasma characteristics.
20 May 2021 in Electronics Letters
In this letter, we study the design of three‐dimensional (3D)‐printed ceramics exhibiting anisotropic dielectric permittivities at microwave frequencies for dielectric resonator antenna (DRA) applications. The anisotropy is engineered by using periodic structures made up of subwavelength asymmetric unit cells filled with zirconia and air. Ceramic samples with uniaxial anisotropy are designed, 3D‐printed, and measured. Birefringence up to 8 is achieved by controlling the volume fill rate of the unit cell. Besides, a single‐fed circularly polarised (CP) DRA that relies on a 3‐D‐printed uniaxial anisotropic ceramic is proposed in the 2.45 GHz ISM band. Its simulated and measured reflection coefficient, axial ratio, and realised gain patterns are in good agreement, thus demonstrating the possibility of exploiting 3‐D‐printed anisotropic ceramics for DRA applications.
1 July 2022 in Physics of Plasmas
Hall thrusters are known to exhibit a large variety of instabilities. Their physical mechanisms have been identified at low (kHz) and intermediate (MHz) frequencies, even though they are still not fully understood. Furthermore, electromagnetic radiations generated by Hall thrusters, named “self-emission” of the thruster, have been measured from kHz to MHz as expected from the identified instabilities, but also at higher frequencies. The origin of the high frequency (GHz) self-emission remains for now unknown. Assessing this self-emission, that is important for understanding the physics of Hall thrusters as well as for electromagnetic compatibility issues with the spacecraft, is challenging. Another aspect that makes the understanding of the physics of Hall thrusters complex comes from the eventual coupling between instabilities, which has been recently suggested and observed. The aim of this paper is to explore the possibility of characterizing simultaneously instabilities in Hall thrusters on a broadband frequency range (from kHz to GHz) in situ, meaning in a conventionally used vacuum chamber where Hall thrusters are usually operated. We show in this paper that, despite the reverberant nature of the vacuum metallic chamber, useful information is extracted at low and intermediate frequencies and even at high frequency from the measurements done with an antenna in this environment.
7 October 2019 in Applied Physics Letters
We report the experimental demonstration of plasma generation by time-reversal focusing. After a learning phase, the amplified time reversed signal built at a central frequency of 2.45 GHz injected in a low loss metallic cavity allows us to ignite and maintain a localized centimeter-sized plasma in argon at 133 Pa. The plasma spatial position is totally controlled by the signal waveform.
1 July 2015 in Electronics Letters
The use of microplasma discharges as power‐induced limiter elements in microstrip devices is proposed to protect receivers against high‐power microwave threats. A microstrip bandpass filter integrating such a microplasma‐based active microwave power limiter has been designed and measured. Power limitation is observed when the input power exceeds 19 dBm with a leakage power of 14 dBm. Due to the gaseous properties of the active medium, the proposed structure exhibits a very low additional insertion loss of 0.06 dB.
5 June 2018 in IEEE Transactions on Plasma Science
Plasma-based microwave power limitation is experimentally investigated in a microstrip transmission line integrating a direct current (dc) plasma discharge for preionization. Steady state and transient high-power microwave measurements demonstrate that the preionization by the dc plasma discharge helps in reducing limiting power thresholds and time responses to about 30 dBm and tens to few microsecond, respectively. Besides, optical diagnostics also exhibit interesting behaviors of the plasma discharge such as diffusion and parasitic breakdowns. Finally, the effect of plasma confinement is discussed, and it is shown that reducing the volume devoted to plasma expansion leads to a decrease in the dynamic range of the microwave power limitation.