Androula Galiouna Nassiopoulou

Androula Galiouna Nassiopoulou

Auto-generated profile, based on publicly available information

Androula Galiouna Nassiopoulou


Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 April 2016 in Discover Nano
Verified
Journal Article
Open access
PDF file
KVKaterina Valalaki
Katerina Valalaki
PBPhilippe Benech
Philippe Benech
ANAndroula Galiouna Nassiopoulou
Androula Galiouna Nassiopoulou
In-plane Seebeck coefficient of porous Si free-standing membranes of different porosities was accurately measured at room temperature. Quasi-steady-state differential Seebeck coefficient method was used for the measurements. A detailed description of our home-built setup is presented. The Seebeck coefficient was proved to increase with increasing porosity up to a maximum of ~1 mV/K for the ~50 % porosity membrane, which is more than a threefold increase compared to the starting highly doped bulk c-Si substrate. By further increasing porosity and after a maximum is reached, the Seebeck coefficient sharply decreases and stabilizes at ~600 μV/K. The possible mechanisms that determine this behaviour are discussed, supported by structural characterization and photoluminescence measurements. The decrease in nanostructure size and increase in carrier depletion with increasing porosity, together with the complex structure and morphology of porous Si, are at the origin of complex energy filtering and phonon drag effects. All the above contribute to the observed anomalous behaviour of thermopower as a function of porosity and will be discussed.

10 September 2018 in ACS Omega
Verified
Journal Article
Open access
ILIoannis Leontis
Ioannis Leontis
MBMartha A. Botzakaki
Martha A. Botzakaki
SGStavroula N. Georga
Stavroula N. Georga
ANA. Galiouna Nassiopoulou
A. Galiouna Nassiopoulou
Si nanowires (SiNWs) produced by metal-assisted chemical etching on n-type Si were investigated for their use as a light-trapping material in c-Si solar cells. The nanowires were fabricated before junction formation (on a lightly doped Si substrate) so that their core was bulk and nonporous. The above fabrication process was implemented in solar cell fabrication. The SiNW reflectivity was tested at different steps of solar cell processing and found to be lower than that of conventional random pyramids used in c-Si solar cells. Contact formation on the front side of the cell was investigated by considering metal deposition either directly on the nanowires or on bulk areas in between the nanowire areas. The superiority of this second case was demonstrated. Three different Si nanowire lengths were investigated, namely, 0.5, 1, and 1.5 μm, the case of 1 μm giving better results in terms of solar cell characteristics and external quantum efficiency. The electronic quality of the Si nanowire surface was investigated using the corresponding metal-oxide-semiconductor capacitors with atomic-layer-deposited alumina dielectric. Successful reduction of surface recombination centers at the large Si nanowire surface was achieved by reducing structural defects at their surface through a specific chemical treatment. Finally, using the determined optimized conditions for Si nanowire formation, chemical cleaning, and process implementation in solar cell fabrication, we demonstrated ∼45% increase in solar cell efficiency with 1 μm SiNWs compared to that from a flat reference cell processed under similar conditions. The above study was made on test solar cells without surface passivation.

17 November 2015 in Journal of Applied Physics
Verified
Journal Article
Closed access
MZMatthew Zervos
Matthew Zervos
AOA. Othonos
A. Othonos
VGV. Gianneta
V. Gianneta
ATA. Travlos
A. Travlos
ANA. G. Nassiopoulou
A. G. Nassiopoulou
Sn doped β-Ga2O3 nanowires have been grown on Si(001) via the vapor–liquid–solid mechanism at 800 °C over a broad range of compositions. These have a monoclinic β-Ga2O3 crystal structure and minimum resistances for 1–2 at. % Sn but we observe the emergence of tetragonal rutile SnO2 which dominates with increasing content of Sn. All of the nanowires exhibited photoluminescence at 2.7 eV but a red shift of the emission occurred from 2.7 eV to 1.8 eV after post growth processing under H2S above 500 °C. The red emission is related to deep donor to acceptor transitions and the formation of monoclinic β-Ga2S3 and has been exploited for spectral shifting in a Si solar cell resulting into an increase of the power conversion efficiency from 7.2% to 8.3%.

15 July 2016 in Journal of Physics D: Applied Physics
Verified
Journal Article
Closed access
PDF file
KVK Valalaki
K Valalaki
NVN Vouroutzis
N Vouroutzis
ANA G Nassiopoulou
A G Nassiopoulou
The thermoelectric properties of p-type polycrystalline silicon thin films deposited by low pressure chemical vapour deposition (LPCVD) were accurately determined at room temperature and the thermoelectric figure of merit was deduced as a function of film thickness, ranging from 100 to 500 nm. The effect of film thickness on their thermoelectric performance is discussed. More than threefold increase in the thermoelectric figure of merit of the 100 nm thick polysilicon film was observed compared to the 500 nm thick film, reaching a value as high as 0.033. This enhancement is mainly the result of the smaller grain size in the thinner films. With the decrease in grain size the resistivity of the films is increased twofold and electrical conductivity decreased, however the Seebeck coefficient is increased by 30% and the thermal conductivity is decreased eightfold, being mainly at the origin of the increased figure of merit of the 100 nm film. Our experimental results were compared to known theoretical models and the possible mechanisms involved are presented and discussed.

28 June 2016 in Journal of Applied Physics
Verified
Journal Article
Closed access
ILI. Leontis
I. Leontis
MBM. A. Botzakaki
M. A. Botzakaki
SGS. N. Georga
S. N. Georga
ANA. G. Nassiopoulou
A. G. Nassiopoulou
High capacitance density three-dimensional (3D) metal-insulator-semiconductor (MIS) capacitors using Si nanowires (SiNWs) by metal-assisted chemical etching and atomic-layer-deposited alumina dielectric film were fabricated and electrically characterized. A chemical treatment was used to remove structural defects from the nanowire surface, in order to reduce the density of interface traps at the Al2O3/SiNW interface. SiNWs with two different lengths, namely, 1.3 μm and 2.4 μm, were studied. A four-fold capacitance density increase compared to a planar reference capacitor was achieved with the 1.3 μm SiNWs. In the case of the 2.4 μm SiNWs this increase was ×7, reaching a value of 4.1 μF/cm2. Capacitance-voltage (C-V) measurements revealed that, following a two-cycle chemical treatment, frequency dispersion at accumulation regime and flat-band voltage shift disappeared in the case of the 1.3 μm SiNWs, which is indicative of effective removal of structural defects at the SiNW surface. In the case of the 2.4 μm SiNWs, frequency dispersion at accumulation persisted even after the two-step chemical treatment. This is attributed to a porous Si layer at the SiNW tops, which is not effectively removed by the chemical treatment. The electrical losses of MIS capacitors in both cases of SiNW lengths were studied and will be discussed.

16 August 2018 in ACS Applied Energy Materials
Verified
Journal Article
Closed access
Vesselin DonchevVesselin Donchev
Vesselin Donchev
SGS. Georgiev
S. Georgiev
ILI. Leontis
I. Leontis
ANA. G. Nassiopoulou
A. G. Nassiopoulou