31 May 2016 in International Journal of Civil Engineering
9 August 2019 in Bulletin of Engineering Geology and the Environment
27 May 2019 in European Journal of Environmental and Civil Engineering
In current article, results of large monotonic pull out tests performed on clays reinforced with two different geogrids (i.e. G1 & G2) encapsulated with thin layers of granular soil of different grain size (i.e. Sand A & B) have been presented. Tests were carried out using a rate of displacement of 1.0 mm/min, normal pressures of 25, 50 and 100 kPa and granular layer thicknesses of 20, 40, 80 and 100 mm. Results showed that encapsulating geogrids in thin granular layers under pull out conditions significantly enhances clay/geogrid interactions and resistance to pull out. Resistance to pull out of geogrid embedded in sand B with larger average grain size (i.e. D50 = 3.1 mm) and greater shear strength were consistently higher than those embedded in sand A with smaller average grain size (i.e. D50 = 1.6 mm) and lesser shear strength. Enhancements also depend on the lower ratio between equivalent thickness of transverse members and the average soil grain size. The rate of resistance mobilisation as well as peak pull out resistance in samples reinforced with the stiffer geogrid (i.e. G1) were consistently was faster and greater than those reinforced with geogrid G2.
26 March 2018 in European Journal of Environmental and Civil Engineering
MGMahdi Safdari Seh Gonbad
Soil reinforcement employing geosynthetics is significantly influenced by interactions which are governed by friction and adhesion at interface. To enhance interactions at soil–geogrid interface under direct shear conditions, effects of attaching elements as anchors to reinforcement has been evaluated. A well and poorly graded sand, one geogrid type, anchors with three different size and clamping lengths of 2, 4 and 6 cm from shear surface were used. Samples were prepared with a relative density of 80% and tested dry under normal pressures of 12.5, 25 and 50 kPa using large direct shear test. Factors investigated included soil grading and particle size, anchor size and anchorage length together with normal pressures. Results shows by attachment of anchors to upper geogrid surface, shear resistance to failure is significantly enhanced with increase in normal pressure and anchor size. This is attributed to soil-anchor friction at interfaces, mobilisation of soil passive resistance in front of anchors and tensile strength of reinforcement. Non-uniform sand having larger and angular particles resulted in more effective interactions with geogrid and anchors at interfaces and resulted in greater resistance to shear failure under direct shear loading. Soil particle size and anchorage length were found to be less influential factors on soil–geogrid interactions.
16 August 2023 in International Journal of Geosynthetics and Ground Engineering
3 September 2020 in Geotechnical and Geological Engineering