The assembly of fuel cell stacks presents some unresolved engineering challenges. The aim of this work is to provide a comprehensive solution concept that addresses the identified issues. A product analysis was conducted, from which the assembly process chain could be derived. Subsequently, the problems encountered during assembly were structured and presented. Finally, a solution concept was developed that addresses both the overarching problem and the process-specific difficulties. The analysis shows the necessity of a cost degression of the stacks through full automation of the assembly systems. However, this represents a significant economic risk, which is why a scalable assembly in terms of automation level is proposed. The problem of process complexity and a generally low level of product knowledge is addressed by the introduction of cognitive and physical assistance systems in the low automation stages. To increase the speed of knowledge building in terms of product, process and equipment, algorithms for self-optimizing processes or for outputting action recommendations are used. The control complexity arises from high speed and accuracy requirements of the stacking process, which is addressed in a novel approach using continuous drive technology.
Fuel cell systems will play an important role in the achievement of global climate goals, particularly in the building and transportation sectors. However, manufacturers face several challenges in the production of these systems, arising primarily from the complexity of products, processes, and equipment as well as the associated data processing requirements. This paper briefly outlines the challenges in the assembly of fuel cell stacks and introduces a specific design of a Digital Twin that addresses them with the help of tailored data management, data evaluation and information utilization. This is followed by the presentation of two potential application scenarios: the use of the Digital Twin as the basis for an expert system that accelerates scaling from prototype to series assembly and as a tool for end-to-end quality monitoring to continuously optimize the products and processes.
1 January 2009 in Cellular Physiology and Biochemistry