17 August 2022 in IEEE Transactions on Geoscience and Remote Sensing
The comparison and verification of ocean wave spectrum by remote sensing and in situ measurements at the spectral level are quite rare because the use of the traditional comparison method leads to very limited spatiotemporal matching pairs. In this article, a new comparison method is proposed. With this method, under different sea conditions (wind wave mainly/swell mainly) and sea surface conditions (wind speed smaller than 20 m/s and significant wave height from 1 to 7 m), mean directional wave height spectra from surface waves investigation and monitoring (SWIM) are compared at the spectral level to the buoy counterparts, in different classes of the sea state. This includes the comparison of the omnidirectional wave height spectrum and the directional function at the peak wavenumber. The comparison results show that, under medium and high sea conditions, wave directional spectra provided by the SWIM beams at 8° and 10° incidence have a high consistency with those from buoy data. Under low sea conditions, the measurement bias of SWIM wave directional spectra mainly comes from three phenomena that are, by order of importance, an abnormal lifting of spectral energy caused by nonwave components at low wave numbers (parasitic peak), from the nonlinear surfboard effect in the radar imaging mechanism, and from a slight underestimation of speckle noise spectral density.
8 September 2015 in Chinese Journal of Oceanology and Limnology
21 October 2011 in Waves in Random and Complex Media
Although the small perturbation method (SPM) for rough surface scattering has been studied extensively in problems in optics, remote sensing and propagation, there are fewer studies on rough surface transmission by the SPM. In this paper, from Huygens’ principle and the extinction theorem, the SPM is used to derive the transmitted field to the second order, and expressions for the bidirectional transmission coefficient and the total surface transmittance to the second order are developed for the random rough surface. The refined expressions can be applied to the situations where the transmission characteristics of a random rough surface need to be more accurately calculated. For example, to calculate the brightness temperature of stratified rough media by the incoherent method, we have to know the bidirectional transmission coefficient or transmittance of random rough surface as accurately as possible. The accuracy of the presented expressions is verified through the conservation of energy. It is shown that the transmission characteristics calculated by SPM to the first order violate conservation of energy, whereas solutions to the second order conform to energy conservation much better. This is particularly important for the calculation of transmittance or emissivity.
28 November 2023 in IEEE Transactions on Geoscience and Remote Sensing
SWIM can provide global wave spectra, but under small sea conditions, the presence of parasitic peaks at low wavenumber, surfboard effects, and residual speckle noise lead to performance degradation of SWIM wave height spectrum products. To reduce the impacts of the factors above on SWIM wave height spectrum, in this paper, a convolution neural network (CNN) method based on BU-Net is proposed for calibrating SWIM omnidirectional wave height spectra with buoy measurements under sea states (wind wave mainly/swell mainly) and sea surface conditions (wind speed from 9m/s to 19m/s, significant wave height from 0.8m to 3.4m~4.2m). The calibration results show that the impact of the factors above on SWIM omnidirectional wave height spectrum can be corrected. The correlation coefficients between the corrected SWIM beams 6°, 8°, 10 ° and the buoy mean omnidirectional wave height spectrum are all greater than 0.90, and the relative error of the peak wave number is within 10%. The relative error of the integrated energy is mostly less than 20%. In addition, the performance of spectral integration parameters (effective wave height Hs , energy wave period T m-10 ) of each spectral beam of SWIM has been verified using MFWAM reanalysis data. The validation results show that RMSE of the Hs and T m-10 , for the corrected SWIM beam 6 ° (8 °, 10 °) under wind wave sea conditions are 0.31m (0.32m, 0.25m) and 0.50s (0.51s, 0.49s) respectively; those for swell cases are 0.16m (0.16m, 0.13m) and 0.87s (0.77s, 0.72s), respectively.