1 April 2010 in Procedia Engineering
In the present work, the influence of the heat treatment on the evolution of oligocyclic fatigue life on two types of aluminium alloys was studied. The two alloys (2024 and 2024 plated by 1050) are largely used in the aircraft industry because of their good mechanical characteristics and their lightness. The main factor of heat treatment influencing fatigue behavior in these two types of alloys is the precipitation of Al 2 Cu in the 2024 alloy and diffusion of cupper from the middle to the surface in the 2024 plated one. Our work is to locate the effect of heat treatments on different microscopic characteristics and their influence on the evolution fatigue damage, the idea of using heat treatments is based on their role to change the precipitation and the direction of diffusion on those alloys. The results obtained showed that we can increase the fatigue performance in 2024 alloy of about 34% just by using different age hardening, so this process of age hardening can be envisaged to increase the fatigue life of aluminium components when these are submitted to fatigue loading, however, in the case of 2024 plated alloy, the diffusion phenomenon has made their surface very fragile, what led to the reduction in their lifespan. Microstructural investigations, such as scanning electron microscopy and micro hardness, were carried out in order to observe the microstructural evolution due to heat treatment and fatigue
11 September 2023 in Experimental Techniques
1 January 2011 in Procedia Engineering
The present work is devoted to study the influence of high cycle fatigue damage rate at R = 0.1, on the mechanical properties of aluminum alloy 2024-T3 which is largely used in aircraft industry. The study consists of an experimental investigation in the evolution of the static properties such as the modulus of elasticity, yield and ultimate stress, lengthening, micro-hardness, electrical resistivity and microstructural investigation in Scanning Electronic Microscopy. Our work is to locate the effect of different rate of residual fatigue damage on evolution of the characteristics above compared with the virgin state “without damage”. The results obtained show that, under the present experimental conditions, the mechanical properties are not very sensitive to fatigue damage. However, the degree of hardening and the electrical resistivity increase with increasing number of fatigue cycles, this increase of the hardness parameters and electrical resistivity could be attributed to microcracks evolution during high cycle fatigue, which are revealed by SEM observations. The observed results provide a basis for developing concepts to early detect and also monitor fatigue damage accumulation in aluminum aircraft structures based on measurements of the material's hardness changes
1 June 2013 in Materials Science and Engineering: A
20 October 2023 in Bulletin of Materials Science
17 June 2024 in International Journal of Applied Ceramic Technology