24 April 2014 in Journal of Geophysical Research: Earth Surface
A model of sand transport in water is produced by combining a turbulence-resolving large eddy simulation (LES) with a discrete element model (DEM) prescribing the motion of individual grains of medium sand. The momentum effect of each particle on the fluid is calculated at the LES cell containing the particle, and the fluid velocity and pressure, interpolated to each particle center, is used to derive fluid force on each particle in the DEM. Eleven numerical experiments are conducted of an initially flat bed of particles. The experiments span a range of motion, from essentially no motion to vigorous suspension. Hydraulic roughness is found to increase abruptly at the transition from bed load to suspended load transport. Suspended sediment extracts momentum from the flow and decreases the rate of shear. Whereas, slightly higher in the flow, vertical drag by suspended grains damps turbulence and increases the rate of shear. Vertical sediment diffusivity and effective particle settling velocity are much smaller than is commonly assumed in suspended sediment models. The bed load experiments suggest that saltation by itself is a poor model of bed load sand transport. In contrast to expectations from saltation models, the peak bed load flux occurs at essentially the same level as the bed, and grains move slowly in frequent contact with other grains. Higher- and faster-moving bed load grains that can be considered to be in saltation represent a smaller portion of the total flux. Entrainment of bed load grains occurs in response to fluid penetration of the bed by high-vorticity turbulence structures embedded within broader high speed fluid regions referred to as a sweeps or high-speed wedges.
17 June 2013 in Journal of Geophysical Research: Earth Surface
Vegetation is ubiquitous in river channels and floodplains and alters mean flow conditions and turbulence. However, the effects of vegetation patches on near‐bed turbulence, bed load transport rates, and sedimentation are not well understood. To elucidate the influence of emergent vegetation on local and patch‐averaged bed load transport, we conducted a set of experiments in which we varied the mean flow velocity (U), total boundary shear stress (τ), or vegetation density between runs. We measured 2D velocity fields using Particle Imaging Velocimetry and bed load fluxes using high‐speed video. Simulated rigid vegetation caused bed load fluxes to vary spatially by an order of magnitude, causing distinct scour zones adjacent to, and depositional bed forms between stems. These local patterns of sedimentation could impact recruitment and survival of other plants. Large bed load fluxes were collocated with high near‐bed turbulence intensities that were three to four times larger than spatially averaged values. Higher vegetation densities increased the importance of inward and outward interactions, particularly downstream of vegetation. At the patch scale, greater stem densities caused either an increase or decrease in run‐averaged bed load fluxes, depending on whether U or τ was held constant between runs. This implies that sedimentation in vegetation patches is not only a function of bed grain size, sediment supply, and vegetation density and species, but whether vegetation significantly impacts mean and local flow properties, which could depend on vegetation location. Commonly used bed load transport equations did not accurately predict average sediment fluxes in our experiments unless they accounted for the spatial variability in the near‐bed Reynolds stress.
11 April 2007 in Journal of Geophysical Research: Earth Surface
In natural flows, bed sediment particles are entrained and moved by the fluctuating forces, such as lift and drag, exerted by the overlying flow on the particles. To develop a better understanding of these forces and the relation of the forces to the local flow, the downstream and vertical components of force on near‐bed fixed particles and of fluid velocity above or in front of them were measured synchronously at turbulence‐resolving frequencies (200 or 500 Hz) in a laboratory flume. Measurements were made for a spherical test particle fixed at various heights above a smooth bed, above a smooth bed downstream of a downstream‐facing step, and in a gravel bed of similarly sized particles as well as for a cubical test particle and 7 natural particles above a smooth bed. Horizontal force was well correlated with downstream velocity and not correlated with vertical velocity or vertical momentum flux. The standard drag formula worked well to predict the horizontal force, but the required value of the drag coefficient was significantly higher than generally used to model bed load motion. For the spheres, cubes, and natural particles, average drag coefficients were found to be 0.76, 1.36, and 0.91, respectively. For comparison, the drag coefficient for a sphere settling in still water at similar particle Reynolds numbers is only about 0.4. The variability of the horizontal force relative to its mean was strongly increased by the presence of the step and the gravel bed. Peak deviations were about 30% of the mean force for the sphere over the smooth bed, about twice the mean with the step, and 4 times it for the sphere protruding roughly half its diameter above the gravel bed. Vertical force correlated poorly with downstream velocity, vertical velocity, and vertical momentum flux whether measured over or ahead of the test particle. Typical formulas for shear‐induced lift based on Bernoulli's principle poorly predict the vertical forces on near‐bed particles. The measurements suggest that particle‐scale pressure variations associated with turbulence are significant in the particle momentum balance.
15 April 2003 in Sedimentology
21 September 2012 in Journal of Geophysical Research: Earth Surface
16 January 2007 in Journal of Geophysical Research: Earth Surface