15 July 2013 in Applied Physics Letters
Hall effect and capacitance-voltage C(V) measurements were performed on p-type GaN:Mg layers grown on GaN templates by molecular beam epitaxy with a high range of Mg-doping concentrations. The free hole density and the effective dopant concentration as a function of magnesium incorporation measured by secondary ion mass spectroscopy clearly reveal both a magnesium doping efficiency up to 90% and a strong dependence of the acceptor ionization energy Ea with the acceptor concentration NA. These experimental observations highlight an isolated acceptor binding energy of meV compatible, at high acceptor concentration, with the achievement of p-type GaN:Mg layers with a hole concentration at room temperature close to .
15 January 2011 in Journal of Applied Physics
GPGuillaume Perillat-Merceroz
Guillaume Perillat-Merceroz
Although zinc oxide is a promising material for the fabrication of short wavelength optoelectronic devices, -type doping is a step that remains challenging for the realization of diodes. Out of equilibrium methods such as ion implantation are expected to dope ZnO successfully provided that the non-radiative defects introduced by implantation can be annealed out. In this study, ZnO substrates are implanted with nitrogen ions, and the extended defects induced by implantation are studied by transmission electron microscopy and x-ray diffraction (XRD) before and after annealing at . Before annealing, these defects are identified to be dislocation loops lying either in basal planes in high N concentration regions, or in prismatic planes in low N concentration regions, together with linear dislocations. An uniaxial deformation of 0.4% along the axis, caused by the predominant basal loops, is measured by XRD in the implanted layer. After annealing, prismatic loops disappear while the density of basal loops decreases and their diameter increases. Moreover, dislocation loops disappear completely from the subsurface region. XRD measurements show a residual deformation of only 0.05% in the implanted and annealed layer. The fact that basal loops are favored against prismatic ones at high N concentration or high temperature is attributed to a lower stacking fault energy in these conditions. The coalescence of loops and their disappearance in the subsurface region are ascribed to point defect diffusion. Finally, the electrical and optical properties of nitrogen-implanted ZnO are correlated with the observed structural features.
30 January 2012 in Applied Physics Letters
The residual n-type conductivity of O-polar hydrothermally grown ZnO single crystals and the role of annealing on the transport properties are assessed by temperature dependent Hall measurements on a wide 20–800 K temperature range. A deep level lying 250 meV below the conduction band is responsible for the residual n-type conductivity of unannealed samples. After annealing, a shallow donor level with 25 meV ionization energy becomes responsible for the sample conductivity in the room temperature range. Thanks to high temperature Hall measurement, the coexistence of the deep and the shallow level has been demonstrated in the case of annealed sample.
8 April 2013 in Applied Physics Letters
In this paper, the optical signatures of arsenic complexes in As-doped HgCdTe samples grown by molecular beam epitaxy are clearly identified using comparison between photoluminescence spectra, Extended X-Ray Absorption Fine Structure, and Hall measurements. The ionization energies of the different complexes are measured both by photoluminescence and Hall measurements.
28 March 2011 in Applied Physics Letters
Photoluminescence and temperature-dependent Hall measurements of nonintentionally doped HgCdTe epilayers were compared. These films were grown by liquid phase epitaxy and postannealed under different conditions as follows: a p-type annealing was used to control the mercury vacancy concentration and a n-type annealing under saturated Hg atmosphere was used to fill the mercury vacancies. The comparison of the photoluminescence measurements with Hall effect measurements allows us to identify the two acceptor energy levels of the mercury vacancy and to evidence its “negative-U” property corresponding to a stabilization of the ionized state of the mercury vacancy compared to its neutral state .
1 November 2010 in Journal of Crystal Growth