15 November 2018 in Materials Research Express
In this study, the influence of shear rate on the Trommsdorff effect was investigated using rotational rheometer and torque rheometer firstly, then the bulk copolymerization of methyl methacrylate (MMA) and maleic anhydride (MAH) were carried out via two connected twin-screw extruders. Based on the assumption of utilizing the Trommsdorff effect, new monomers were continually added during the copolymerization process. The results indicated that the polymerization rate was greatly accelerated and copolymers with high molecular weight and narrow distribution were obtained. Under the high temperature and high pressure in extruder, the copolymerization of MMA and MAH approached to the ideal copolymerization, which was different from the solution copolymerization. Compared with the homo-polymethyl methacrylate, the Tg and Td50 of the copolymer was respectively increased by 12oC and 24oC while maleic anhydride units were uniformly distributed in the MMA-MAH copolymer. The flexural strength and modulus increased by 8.2% and 20%, respectively. The high efficiency and environment friendly of reactive extrusion technology provide a way for the large-scale industrialization of MMA-MAH copolymer.
1 September 2020 in Materials Research Express
In this work, the influence of initial viscosity on the Trommsdorff effect was firstly investigated, and it was confirmed that 1000 ± 100 Pa · s of viscosity could be a criterion of the Trommsdorff effect. On this basis, a new inverted two-stage extruder was established, the designed ‘blocking unit’ was introduced to the screw configuration, and then the continuous bulk copolymerization of methyl methacrylate (MMA) and styrene (St) was carried out. The results showed that the blocking unit could effectively enhance the residence time of copolymerization, and make the molecular weight distribution of copolymer more uniform. The position of the Trommsdorff effect in the extruder was then determined by the thermal effect of copolymerization, and the mixed monomers were continuously added to effectively utilize the Trommsdorff effect. As a result, the MMA-St copolymers with high molecular weight and narrow distribution were prepared via reactive extrusion, which possessed higher melt flow rate and better thermal stability than pure-PMMA. The present work provides important reference and guidance for the industrialization of bulk free radical copolymerization via reactive extrusion.
1 March 2022 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
Continuous drive friction welding (CDFW) is an economical and productive method for joining similar metals. In this study, 45 # steel was joined via CDFW, and the material heat distribution, flow behaviour, flash formation and fracture mode were investigated via experiments and simulations. The bar was divided into three zones in the direction of radius (R), the R zone near the axis, the edge zone at the edge of the R and the 0.5 R zone between the R zone and edge zone. The maximum flow velocity and temperature of the joint first appeared in the 0.5 R zone, and as the friction continued, the maximum temperature moved to the edge zone, followed by flash. When the friction time was 9 s, the maximum tensile strength was 674 MPa, the fracture mode was the coexistence of ductile and brittle and the fracture location had an obvious boundary. Ductile fracture occurred in the R zone, and the flash took a lot of heat, brittle fracture occurred in the 0.5 R and edge zones. The maximum microhardness of the joint is 295 HV in the weld zone, and the microhardness decreased in the partially deformed zone. When the friction time was appropriate, the heat distribution was uniform and sufficient, and the grains exhibited a significant degree of dynamic recrystallisation refinement.
10 August 2021 in Polymers for Advanced Technologies