28 May 2019 in IEEE Transactions on Communications
In this paper, a novel dynamic multiple access technology selection among orthogonal multiple access (OMA) and non-orthogonal multiple access (NOMA) techniques is proposed. For this setup, a joint resource allocation problem is formulated in which a new set of access technology selection parameters along with power and subcarrier are allocated for each user based on each user’s channel state information. Here, a novel utility function is defined to take into account the rate and costs of access technologies. This cost reflects both the complexity of performing successive interference cancellation and the complexity incurred to guarantee a desired bit error rate. This utility function can inherently capture the tradeoff between OMA and NOMA. Due to non-convexity of the proposed resource allocation problem, a successive convex approximation is developed in which a two-step iterative algorithm is applied. In the first step, called access technology selection, the problem is transformed into a linear integer programming problem, and then, in the second step, a nonconvex problem, referred to power allocation problem, is solved via the difference-of-convex-functions (DC) programming. Moreover, the closed-form solution for power allocation in the second step is derived. For diverse network performance criteria such as rate, simulation results show that the proposed new dynamic access technology selection outperforms single-technology OMA or NOMA multiple access solutions.
14 November 2023 in Computer Communications
25 September 2014 in IEEE Transactions on Communications
The nonlinear behavior of power amplifier (PA) in orthogonal frequency-division multiplexing (OFDM)-based cognitive radio (CR) system introduces in-band and adjacent channel interferences. The power in the adjacent channels is an important issue in the CR because it can act as interference to primary users. In this paper, we derive a closed-form expression for the leakage power at adjacent channels when CR devices use OFDM modulation. Moreover, the PA nonlinearity creates in-band distortion that produces intercarrier interference and reduces the secondary system capacity. To control this effect, we derive the optimum power scaling factor for the input signal that maximizes the secondary user rate. The optimization process is executed by considering nonlinear effects on signal-to-interference-and-noise ratio under the constraints of the powers in the adjacent channels. The power in the adjacent channels should not exceed the interference temperature limit. The analytical results are verified by simulation studies.
26 July 2018 in IEEE Wireless Communications Letters
We investigate the problem of the rate maximization of a generalized frequency division multiplexing (GFDM) based secondary user (SU) link operating over a spectrum hole where adjacent channel interference (ACI) on two active primary users (PUs) in the right and left adjacent channels must be below a threshold. The SU transmitter has nonlinear power amplifier (PA) distortions. We consider a zero forcing (ZF) receiver which removes self-generated interference of GFDM. For a third-order nonlinear PA, we derive the signal-to-interference-plus noise ratio (SINR) and ACI. By using successive convex approximations, we develop a power allocation algorithm to maximize the SU rate subject to the ACI limits on adjacent PUs. Finally, we show that the proposed algorithm improves the SU data rate and that GFDM achieves a higher SU data rate than orthogonal frequency division multiplexing (OFDM).
5 March 2017 in Transactions on Emerging Telecommunications Technologies
19 June 2018 in Transactions on Emerging Telecommunications Technologies