The occurrence of deep-sea geohazards is accompanied by dynamic changes in the physical properties of seafloor sediments. Therefore, studying the physical properties is helpful for monitoring and early warnings of deep-sea geohazards. Existing physical property inversion methods have problems regarding the poor inversion accuracy and limited application scope. To address these issues, we establish a deep learning model between the resistivity of seafloor sediment and its density, water content, and porosity. Compared with empirical formulas, the deep learning model has the advantages of a more concentrated prediction range and a higher prediction accuracy. This algorithm was applied to invert the spatial distribution characteristics and temporal variation of the seafloor sediment density, water content, and porosity in the South China Sea hydrate test area for 12 days. The study reveals that the dynamic changes in the physical properties of seafloor sediments in the South China Sea hydrate zone exhibit obvious stratification characteristics. The dynamic changes in the physical properties of seafloor sediments are mainly observed at depths of 0–0.9 m below the seafloor, and the sediment properties remain stable at depths of 0.9–1.8 m below the seafloor. This study achieves the monitoring and early warning of dynamic changes in the physical properties of seafloor sediments and provides a guarantee for the safe construction of marine engineering.
With the consumption of terrestrial metal resources, deep-sea polymetallic nodule minerals have been widely exploited around the world. Therefore, the environmental impact of deep-sea polymetallic nodule mining cannot be ignored. In this study, for the first time, a field disturbance and observation device, integrated with multiple sensors, is used to simulate the disturbance process of mining on seabed sediments in the polymetallic nodule area of the western Pacific Ocean at a depth of 5700 m. The impact of the process of stroking and lifting on the bottom sediment in the polymetallic nodule area is 30 times higher than that caused by the waves or the current. The time for turbidity to return to normal after the increase is about 30 min, and the influence distance of a disturbance to the bottom bed on turbidity is about 126 m. The time it takes for density to return to normal is about four hours, and the influence is about 1000 m. At the same time, the resuspension of the bottom sediment leads to an increase in density anomaly and salinity. Moreover, suspended sediments rich in metal ions may react with dissolved oxygen in water, resulting in a decrease in the dissolved oxygen content and an increase in ORP. During the observation period, the phenomenon of a deep-sea reciprocating current is found, which may cause the suspended sediment generated by the continuous operation of the mining vehicle to produce suspended sediment clouds in the water near the bottom of the mining area. This could lead to the continuous increase in nutrients in the water near the bottom of the mining area and the continuous reduction in dissolved oxygen, which will have a significant impact on the local ecological environment. Therefore, the way mining vehicles dig and wash in water bodies could have a marked impact on the marine environment. We suggest adopting the technology of suction and ore separation on mining ships, as well as bringing the separated sediment back to the land for comprehensive utilization.
The drastic changes in the marine environment can induce the instability of seabed sediments, threatening the safety of marine engineering facilities such as offshore oil platforms, oil pipelines, and submarine optical cables. Due to the lack of long-term in situ observation equipment for the engineering properties of seabed sediments, most existing studies have focused on phenomena such as the erosion suspension of the seabed boundary layer and wave-induced liquefaction, leading to insufficient understanding of the dynamic processes affecting the seabed environment. In this study, a long-term in situ observation system for subsea engineering geological environments was developed and deployed for 36 days of continuous monitoring in the offshore area of Qingdao. It was found that wave action significantly altered sediment mechanical properties, with a 5% sound velocity increase correlating to 39% lower compression, 7% higher cohesion, 11% greater internal friction angle, and 50% reduced excess pore water pressure at 1.0–1.8 m depth. suggesting sustained 2.2 m wave loads of expelled pore water, driving dynamic mechanical property variations in seabed sediments. This long-term in situ observation lays the foundation for the monitoring and early warning of marine engineering geological disasters.