A 120-mm wide amorphous ribbon of a Fe-Co-Si-B-P-Cu NANOMET® alloy has been successfully produced by a single roll melt spinning technique. The optimally annealed samples exhibited low coercivity (Hc) of 5–7 A/m and high saturation magnetic flux density (Bs) of 1.83 T. The plots of Hc and Bs vs. annealing temperature (Ta) revealed basin-like and plateau-like characteristics, respectively, indicating the good annealing controllability for nanocrystallization and for obtaining soft-magnetic properties with high Bs. The excellent magnetic softness was attributed to the nanocrystalline structure composed of homogeneously dispersed α-Fe grains (with a size of 15–20 nm in diameter) emerged from the amorphous structure after optimum annealing. The nanocrystalline ribbons also exhibited low core-losses (W at 50 Hz) of 0.37 and 0.64 W/kg under maximum flux density of 1.5 T and 1.7 T, respectively. The magnetic properties were comparable with those of laboratory-scale small-width ribbons and confirmed to be independent on the ribbon width, indicating the good reproducibility of this NANOMET® alloy into mass-production-level precursors.
It is known that Cu plays an essential role in reducing the grain size of precipitated bcc Fe(Si) nanocrystallites in a nanocrystalline soft-magnetic Fe85.2Si1B9P4Cu0.8 (NANOMET®) alloys like as an Fe73.5Si13.5B9Nb3Cu1 (FINEMET®). However, significant differences are there between two alloys; NANOMET has much higher iron content (∼85%) than FINEMET (73.5%) and the former contains P instead of Nb for the latter. In the present work, the local structure around Cu in FINEMET was measured by X-ray absorption fine structure (XAFS) at 20 K and compared with those of NANOMET during nanocrystallization. Definite differences between NANOMET and FINEMET are found in the way of the evolution of Cu clusters during nanocrystallization. In FINEMET, an fcc structure of Cu is recognized in an as-quenched ribbon indicating existence of a small number of Cu clusters or a very small size of Cu clusters which is stable up to 450 °C, while the fcc Cu clusters are developed rapidly above 450 °C. An fcc structure of the Cu clusters in FINEMET is retained all the way to the end of the nanocrystallization. On the contrary, for NANOMET the local structure around Cu changes in a sequence as “amorphous → fcc → bcc → fcc” by annealing. The reasons of such different behaviors of the local structure around Cu during nanocrystallization are discussed in terms of different contributions of Cu clusters in bcc Fe precipitation between FINEMET and NANOMET. A significantly fast crystallization process with an extraordinary large heat release can be another reason for the transition of the local structure around Cu from fcc to bcc for NANOMET.
5 January 2024 in Materials Science and Engineering: A
Pressure-induced structural changes in metallic glasses have been of great interest as they are expected to open new ways to synthesize novel materials with unexpected properties. Here, we investigated the effect of simultaneous high-pressure and high-temperature treatment on the structure and properties of a Zr50Cu40Al10 metallic glass by in situ X-ray structure measurement and property analysis of the final material. We found the unusual formation of Cu-rich nanocrystals at high pressure and temperature, accompanied by significant strength and hardness enhancement. Based on reverse Monte Carlo modeling and molecular dynamics simulations, the structure of the metallic glass changed to a densely packed, chemically uniform configuration with high short-range and medium-range ordering at high pressure and temperature. These results show that high-pressure annealing processes provide a new way to improve and control properties without changing their composition.
10 April 2025 in International Journal of Hydrogen Energy