28 August 2019 in IEEE Antennas and Wireless Propagation Letters
A 3D-printed wideband multi-ring dielectric resonator antenna (DRA) is investigated for the first time. It consists of four concentric dielectric rings with decreasing effective dielectric constants in the radial direction. To facilitate the 3D-printed design, a basic unit cubic cell that can be easily adjusted to provide different effective dielectric constants is used. An axial coaxial probe is used to excite the DRA in three transverse magnetic (TM) modes ( $\text{TM}_{01\delta}$ , $\text{TM}_{02\delta}$ , and $\text{TM}_{03\delta}$ ), which are merged to provide a wide impedance bandwidth. For demonstration, a prototype operating in C-band is designed and fabricated using a 3D printer. Its reflection coefficient, radiation pattern, antenna gain, and antenna efficiency are measured, and reasonable agreement between the measured and simulated results is observed. The prototype has a wide measured 10-dB impedance bandwidth of 60.2% (4.3–8.0 GHz) with a low profile of $0.18 \lambda_0$ , where $\lambda_0$ is the wavelength in air at the center frequency (6.15 GHz). The prototype has an average measured antenna efficiency of 89%, with the peak efficiency given by 95%.
11 January 2022 in IEEE Transactions on Vehicular Technology
A three-dimensional (3-D)-printed dual-fed dual-frequency dielectric antenna is investigated for vehicular communications. It combines a dielectric resonator (DR) antenna (DRA) and a dielectric lens antenna (DLA) for the low and high frequency bands, respectively. Both of the antenna parts share the same dielectric body that has three different effective dielectric constants. The DRA is excited by a vertical conducting adhesive strip on its sidewall, whereas the DLA is fed by a separate embedded slot-coupled cylindrical DRA. To verify the idea, a dual-frequency dielectric antenna operating at S - and X -bands is designed and fabricated with a 3-D printer. The S -parameters, radiation patterns, antenna gains, and antenna efficiencies of the two antenna parts are measured, and reasonable agreement between the measured and simulated results is found. The prototype has wide measured S - and X -band 10-dB impedance bandwidths of 40.2% and 19.5%, respectively. Also, its measured isolation between the two ports is desirably over 40 dB across the two bands. The measured peak antenna gains are given by 5.8 and 12.0 dBi in S - and X -bands, which are suitable for short-distance vehicle-to-basestation and long-distance vehicle-to-satellite communications, respectively.
1 April 2022 in IEEE Transactions on Antennas and Propagation
A new 3-D-printed wideband circularly polarized (CP) dielectric resonator antenna (DRA) with two printing materials is investigated. The DRA has a multilayer comb-shaped structure at its top for generating CP fields. Three dielectric strips are embedded inside the DRA body to support multiple transverse-electric (TE) DRA modes to widen the DRA bandwidth. To slightly improve the axial-ratio (AR) performance, the DRA is twisted in the horizontal plane. For demonstration, a prototype operating in C-band was designed and printed with two different materials. The reflection coefficient, AR, radiation pattern, antenna gain, and efficiency of the antenna are measured, and reasonable agreement between the measured and simulated results is observed. The prototype has a measured 10 dB impedance bandwidth of 69.7% (4.80–9.94 GHz) and 3 dB AR bandwidth of 68.6% (4.52–9.24 GHz), achieving a wide overlapping bandwidth of 63.2% (4.80–9.24 GHz). Both the AR and overlapping bandwidths are record-high for a single-fed CP DRA. The prototype has a measured peak antenna gain of 8.3 dBic inside the overlapped passband.
1 September 2019 in IEEE Antennas and Wireless Propagation Letters