18 April 2023 in Measurement Science and Technology
The dynamic mechanical properties and crack evolution characteristics of coal and rock during split Hopkinson pressure bar (SHPB) impact failure are important contents for analysis. In previous studies, the coal and rock specimens used have usually been independent and not closely correlated. In addition, quantitative characterization and analysis methods for coal and rock cracks are immature, and more information has not been fully revealed. The aims of this paper are to comprehensively explore both the dynamic mechanical properties and crack evolution characteristics of coal and rock during impact failure. First, experimental specimens are prepared from coal seam, direct roof rock strata and direct floor rock strata in the same area to highlight the correlations between test pieces. Second, a dynamic strain gauge and high-speed (HS) camera are adopted to reflect the stress wave signal and crack evolution. Then, based on digital image correlation (DIC) technology and the mass screening method, the evolution laws of surface cracks during crushing and the distribution characteristics of sample fragments after crushing are studied from the perspective of fractal, and finally compared with those of the simulation analysis. The results are as follows. (1) The coal and rock samples from the same area have both consistency and differences. The dynamic mechanical properties of coal and rock are affected by the impact velocity and the physical properties of the specimen. Higher impact speeds and densities lead to the more obvious brittleness of the specimen when destroyed. Conversely, the sample shows more plasticity and ductile yield. (2) The self-similarity is significantly manifested in the evolution of surface cracks during impact and the distribution characteristics of fragments after impact. The box dimension and quality screening dimension are applicable to quantitatively characterize the evolution process and results of coal and rock fractures. (3) The simulation results based on the Holmquist–Johnson–Cook (HJC) and Riedel–Hiermaier–Thoma (RHT) constitutive models agree well with the experimental results, and the RHT constitutive model is more consistent. This study may contribute to a more comprehensive understanding of the dynamic characteristics and crack evolution laws of coal and rock under impact loading and provide references for further research and discussion.
13 March 2025 in Chemical Engineering Journal
1 January 2026 in Geofluids
To address the risk of water inrush from old water‐logged goafs during deep and shallow repeated mining, this study investigates the failure characteristics of interlayer water‐resisting rock strata and establishes a corresponding water inrush evaluation method. Based on the roof and floor failure characteristic theories, the failure zoning of interlayer rock strata was distinguished for shallow and deep mining by analyzing their different stress environments and boundary conditions, and the applicable calculation formulas for each zoning index were proposed. For deep mining, the elliptical boundary of the depressurization zone and the tangential stress expression along the ellipse were defined, while the parabolic boundary of the stress concentration zone was determined using three characteristic stress points of the surrounding rock. A case study of a shallow repeated mining coal mine in Shanxi Province was conducted to calculate the failure zoning parameters of interlayer rock strata, identify the formation of water‐conducting channels by the main key layer position, and derive the quantitative relationship between the initial fracture span of the main key layer and the goaf water accumulation height based on the elastic plate theory. The results clarify the differential failure mechanisms of interlayer water‐resisting rock strata under shallow and deep repeated mining. The proposed evaluation method offers a theoretical basis and engineering reference for preventing and controlling roof goaf water inrush in coal mines.