15 January 2013 in Nature Communications
24 May 2012 in Physical Review B
We present a method to reconstruct the nonlinear tip-surface force and extract material properties from a multifrequency atomic force microscopy (AFM) measurement with a high-quality-factor cantilever resonance. In a measurement time of $\sim${}2 ms, we are able to accurately reconstruct the tip-surface force-displacement curve, allowing simultaneous high-resolution imaging of both topography and material properties at typical AFM scan rates. We verify the method using numerical simulations, apply it to experimental data, and use it to image mechanical properties of a polymer blend. We further discuss the limitations of the method and identify suitable operating conditions for AFM experiments.
10 February 2015 in Nature Communications
Atomic force microscopy has recently been extented to bimodal operation, where increased image contrast is achieved through excitation and measurement of two cantilever eigenmodes. This enhanced material contrast is advantageous in analysis of complex heterogeneous materials with phase separation on the micro or nanometre scale. Here we show that much greater image contrast results from analysis of nonlinear response to the bimodal drive, at harmonics and mixing frequencies. The amplitude and phase of up to 17 frequencies are simultaneously measured in a single scan. Using a machine-learning algorithm we demonstrate almost threefold improvement in the ability to separate material components of a polymer blend when including this nonlinear response. Beyond the statistical analysis performed here, analysis of nonlinear response could be used to obtain quantitative material properties at high speeds and with enhanced resolution.
6 October 2014 in Applied Physics Letters
We demonstrate an alternative to Kelvin Probe Force Microscopy for imaging surface potential. The open-loop, single-pass technique applies a low-frequency AC voltage to the atomic force microscopy tip while driving the cantilever near its resonance frequency. Frequency mixing due to the nonlinear capacitance gives intermodulation products of the two drive frequencies near the cantilever resonance, where they are measured with high signal to noise ratio. Analysis of this intermodulation response allows for quantitative reconstruction of the contact potential difference. We derive the theory of the method, validate it with numerical simulation and a control experiment, and we demonstrate its utility for fast imaging of the surface photo-voltage on an organic photo-voltaic material.
1 February 2011 in Review of Scientific Instruments
Nonlinear systems can be probed by driving them with two or more pure tones while measuring the intermodulation products of the drive tones in the response. We describe a digital lockin analyzer which is designed explicitly for this purpose. The analyzer is implemented on a field-programmable gate array, providing speed in analysis, real-time feedback, and stability in operation. The use of the analyzer is demonstrated for intermodulation atomic force microscopy. A generalization of the intermodulation spectral technique to arbitrary drive waveforms is discussed.
14 October 2015 in Soft Matter
CECornelius Anthony van Eysden
Cornelius Anthony van Eysden
Intermodulation atomic force microscopy is used to quantitatively determine both viscous and elastic parameters of a soft material interface. A model of the tip surface interaction is introduced, taking in to account the dynamics of both cantilever and viscoelastic surface.