12 September 2012 in The Journal of Physical Chemistry C
1 October 1991 in Physical Review B
V centers induced by ionizing irradiation at 80 or 300 K in single-crystal and polycrystalline samples have been studied by use of electron paramagnetic resonance and optical absorption. and centers, as a result of hole trapping at tetrahedral and octahedral cation vacancies, respectively, have been found to be responsible for two EPR bands centered at g=2.011 and optical absorption bands involved in the complex absorption spectrum at about 3.4 eV. These centers anneal thermally in a very wide step from 220 to 575 K.
22 March 2004 in Applied Physics Letters
Thin films of amorphous aluminum oxide (a-Al2O3) codoped with Er3+ and Yb3+ ions have been in-depth nanostructured by distributing the rate earth (RE) ions in layers separated in the 0–3 nm range. The Yb to Er concentration ratio is varied from 0 to 3.6. The photoluminescence (PL) response at 1.53 μm exhibits an increase of up to two orders of magnitude with respect to that of films doped only with Er. The PL intensity is improved when Yb3+ and Er3+ ions are in separate layers and the results show that efficient Yb3+ to Er3+ energy transfer can be achieved for separations up to 3 nm. Furthermore, it is shown that designing an adequate RE distribution, for the same total RE content and Yb to Er concentration ratio, can enhance the PL intensity by a further factor of two. It is shown that the Er3+ PL response is improved because of a reduction of the RE clustering and an improvement of the energy transfer from Yb3+ to Er3+ ions.
27 December 2005 in Thin Solid Films
15 November 2001 in Journal of Applied Physics
Erbium doped Al2O3 films with concentrations up to 6×1020 Er cm−3 have been prepared in a single step process by pulsed-laser deposition. Alternate ablation of Al2O3 and Er targets has been used to control the in-depth distribution and in-plane concentration of Er3+ ions independently. The characteristic Er3+ photoluminescence response at 1.53 μm has been studied as a function of the Er3+ distribution. It is found that lifetime values can be greatly increased by increasing the Er3+–Er3+ in-depth separation above 3 nm. This result can be related to a reduced Er3+–Er3+ energy migration process. The in-plane Er3+ concentration was increased by either increasing the number of pulses on the Er target or the laser energy density for ablation. By the latter method in-plane concentrations as high as 1.1×1014 Er cm−2 per layer (corresponding to 2×1020 Er cm−3) were achieved, while keeping lifetime values as high as 6 ms. This result is explained in terms of shallow Er3+ implantation during deposition.
1 July 1991 in Philosophical Magazine Letters