Tungsten is a prime material candidate for the first wall of a future fusion reactor. In the case of a loss-of-coolant accident (LOCA) wall temperatures of about 1450 K could be reached lasting about 30–60 days due to nuclear decay heat. In the worst case scenario combining LOCA with air ingress, the formation and release of highly volatile and radioactive tungsten trioxide (WO3) into the environment can occur. Smart self-passivating tungsten alloys preventing the formation of WO3 can be a way to mitigate this release.In this contribution we present the studies of a new yttrium-containing W-Cr-Y alloys. The extent up to which yttrium acts as an active element improving the adherence and stability of the protective Cr2O3 layer formed during oxidation is assessed. The approach is similar to the one taken for high-temperature steels where active elements stabilize the oxide layers at a substantially reduced thickness by changing the oxygen diffusion and improving the adherence of the protective oxide layer by e.g. avoiding of pores. Further, simulations on mobilized material for the case of a LOCA are developed. In addition, the loss of alloying elements during normal operation of a reactor is estimated. This is done by modelling a thermally activated diffusion, using a diffusion coefficient which is extrapolated from experimental data at higher values.The oxidation behaviour of magnetron sputtered and therefore alloyed at the atomic level W-Cr-Y alloys is tested in a thermo-gravimetric facility. The isothermal oxidations are performed in a gas mixture, containing 20 kPa oxygen and 80 kPa argon under ambient pressure at temperatures of 1273 K and 1473 K, respectively. Experiments with W-Cr-Y show a parabolic oxidation rate of kp=3·10−6mg2cm−4s−1 which is more than five orders of magnitude lower than that of pure tungsten at 1273 K. Investigations using X-ray diffraction analysis and focused ion beam cross-sections in combination with scanning electron microscopy and energy dispersive X-ray spectroscopy are conducted. A protective Cr2O3 layer is detected on the surface with a thickness between 100 and 300 nm
30 September 2010 in Composites Science and Technology
Yttrium oxide thin films were prepared by reactive magnetron sputtering in different deposition condition with various oxygen flow rates. The annealing influence on the yttrium oxide film microstructure is investigated. The oxygen flow shows a hysteresis behavior on the deposition rate. With a low oxygen flow rate, the so called metallic mode process with a high deposition rate (up to 1.4 µm/h) was achieved, while with a high oxygen flow rate, the process was considered to be in the poisoned mode with an extremely low deposition rate (around 20 nm/h). X-ray diffraction (XRD) results show that the yttrium oxide films that were produced in the metallic mode represent a mixture of different crystal structures including the metastable monoclinic phase and the stable cubic phase, while the poisoned mode products show a dominating monoclinic phase. The thin films prepared in metallic mode have relatively dense structures with less porosity. Annealing at 600 °C for 15 h, as a structure stabilizing process, caused a phase transformation that changes the metastable monoclinic phase to stable cubic phase for both poisoned mode and metallic mode. The composition of yttrium oxide thin films changed from nonstoichiometric to stoichiometric together with a lattice parameter variation during annealing process. For the metallic mode deposition however, cracks were formed due to the thermal expansion coefficient difference between thin film and the substrate material which was not seen in poisoned mode deposition. The yttrium oxide thin films that deposited in different modes give various application options as a nuclear material