As one of the new protection technologies in the field of anti-explosion protection of masonry walls, polyurea spraying has attracted wide attention of researchers. This paper established a refined numerical model to predict the dynamic response of unreinforced hollow masonry walls (UWs) and polyurea-reinforced hollow masonry walls (PWs) under blast loading. The numerical simulation results were in good agreement with the reference test results. The progressive failure process of UWs and PWs under blast load was clarified by numerical simulation and failure theory model of wall. According to a series of numerical simulation results, the dimensionless damage parameters (maximum deflection rate and mass loss rate) of the wall were defined, the comprehensive influence of polyurea coating method and blast scaled distance on the damage degree of the wall was summarized, and the damage mode retrieval diagram of polyurea reinforced hollow masonry wall under blast load was established. The results showed that the existence of polyurea coating can provide reliable protection for the wall without catastrophic damage when the blast scaled distance was not less than 1.47 m/kg1/3. The research results of this paper can provide an engineering reference for the polyurea reinforcement of hollow masonry walls.
31 December 2024 in International Journal of Structural Stability and Dynamics
The penetration and reaming performance of a toroidal explosively formed projectile (TEFP) warhead with a charge diameter (D) of 56 mm was investigated when it was used to penetrate Q235 steel targets that were 10 mm thick at different stand-off distances (h). Thought the experimental and numerical result, the formation and penetration mechanisms of TEFP was revealed, and the differences between the radial and axial velocities in various portions of the TEFP were the primary causes of the TEFP expansion and rupture. When the TEFP tail has not completely ruptured and detached (h < 2.14D), TEFP has a strong penetration ability, resulting in TEFP perforating the target plate. The perforation process included three phases: pit opening, plastic hole expansion, and shear-block formation; these phases had average energy consumption ratios of 26.0%, 56.8%, and 17.2%, respectively. Finally, a method of evaluating the perforation and reaming capability of the TEFP was developed and used to identify the optimal stand-off distance, h0 = 1.96D, which produced a penetration hole with a diameter of 1.875D.