The present study estimates the prediction capability of response surface methodology (RSM) and artificial neural network (ANN) models for biodiesel synthesis from sesame (Sesamum indicum L.) oil under ultrasonication (20 kHz and 1.2 kW) using barium hydroxide as a basic heterogeneous catalyst. RSM based on a five level, four factor central composite design, was employed to obtain the best possible combination of catalyst concentration, methanol to oil molar ratio, temperature and reaction time for maximum FAME content. Experimental data were evaluated by applying RSM integrating with desirability function approach. The importance of each independent variable on the response was investigated by using sensitivity analysis. The optimum conditions were found to be catalyst concentration (1.79 wt%), methanol to oil molar ratio (6.69:1), temperature (31.92°C), and reaction time (40.30 min). For these conditions, experimental FAME content of 98.6% was obtained, which was in reasonable agreement with predicted one. The sensitivity analysis confirmed that catalyst concentration was the main factors affecting the FAME content with the relative importance of 36.93%. The lower values of correlation coefficient (R(2)=0.781), root mean square error (RMSE=4.81), standard error of prediction (SEP=6.03) and relative percent deviation (RPD=4.92) for ANN compared to those R(2) (0.596), RMSE (6.79), SEP (8.54) and RPD (6.48) for RSM proved better prediction capability of ANN in predicting the FAME content.
1 April 2015 in International Journal of Hydrogen Energy
This paper presents experimental and theoretical determination of the effective thermal conductivity of various base fluids and nano TiO2 composition. Ultrasonically assisted sol–gel method was used for synthesising anatase TiO2 nanoparticles and dispersing them into base fluids using sonication for the synthesis of nanofluids. It is observed that thermal conductivity enhancement is significantly higher than that of base fluid. The thermal conductivity shows an increment with the addition of nanoparticles and confirms a 22% enhancement achievable in base fluids. The effect of base fluids is a complex idea and difficult to understand; lower base fluid viscosities were supposed to contribute higher in enhancement of thermal conductivity, but another important factor; i.e. fluid nanoparticles surface interaction, nanoparticles crystal type also contributes in enhancement. In the further study, as the sonication time increases; an improvement in the thermal conductivity of nanofluids is also observed. Except water-based nanofluids, all others show reasonably good agreement with the data predicted by Bruggeman model and the prediction is in the range of 5%. This study is important since it covers base fluids with a wide range of thermal conductivity and viscosity.