Electrolyte cost and long-term durability are the two most challenging obstacles to the practical utilization of redox-active organics in aqueous redox flow batteries. Starting from potentially inexpensive 1,8-dihydroxyanthraquinone (1,8-DHAQ), we developed a one-pot, green, and scalable approach to synthesize a highly water-soluble and potentially low-cost anthraquinone 1,8-dihydroxy-2,7-dicarboxymethyl-9,10-anthraquinone (DCDHAQ). The demonstrated volumetric capacity of DCDHAQ in 1 M KOH is 40.2 A h L−1, which is around 70 times higher than that of its precursor 1,8-DHAQ (0.567 A h L−1) at pH 14. The introduction of –CH2CO2− as solubilizing groups suppressed the disproportionation reaction of reduced anthraquinone both thermodynamically and kinetically. Consequently, the cycling stability of anthraquinone was improved significantly compared to that of the precursor. Pairing a negolyte comprising 0.75 M DCDHAQ with a posolyte comprising 0.3 M ferrocyanide at pH 14, we demonstrated a cell with an open-circuit voltage of 1.1 V and a low capacity fade rate of 0.03% per day. The synthetic method of attaching –CH2CO2− as solubilizing groups is likely applicable to other anthraquinone derivatives and other aromatic organics as an inexpensive approach to performance enhancement in energy applications.
Aqueous organic redox flow batteries are promising candidates for large‐scale energy storage. However, the design of stable and inexpensive electrolytes is challenging. Here, we report a highly stable, low redox potential, and potentially inexpensive negolyte species, sodium 3,3′,3′′,3′′′‐((9,10‐anthraquinone‐2,6‐diyl)bis(azanetriyl))tetrakis(propane‐1‐sulfonate) (2,6‐N‐TSAQ), which is synthesized in a single step from inexpensive precursors. Pairing 2,6‐N‐TSAQ with potassium ferrocyanide at pH=14 yielded a battery with the highest open‐circuit voltage, 1.14 V, of any anthraquinone‐based cell with a capacity fade rate <10 %/yr. When 2,6‐N‐TSAQ was cycled at neutral pH, it exhibited two orders of magnitude higher capacity fade rate. The great difference in anthraquinone cycling stability at different pH is interpreted in terms of the thermodynamics of the anthrone formation reaction. This work shows the great potential of organic synthetic chemistry for the development of viable flow battery electrolytes and demonstrates the remarkable performance improvements achievable with an understanding of decomposition mechanisms.
24 September 2024 in ACS Applied Materials & Interfaces
Aqueous redox flow batteries (ARFBs) with neutral electrolytes show promise for large-scale energy storage owing to their relatively low cost and inherent safety. However, the performance of these ARFBs has been limited by the low solubility of electroactive species and/or low cell voltages. In this study, an asymmetric viologen-based compound called MMV (1-Methyl-4,4′-bipyridylium iodide) was assessed as the redox active compound in the negolyte of ARFBs. Inexpensive starting materials and a simple synthesis route yielded MMV at a low cost. MMV exhibited a solubility of ∼3 M in water, and electrochemical measurements confirmed that the reaction of MMV involves the transfer of a single electron with relatively fast kinetics. Importantly, MMV with an asymmetric structure demonstrated a redox potential of −1.05 V vs SCE, one of the most negative potentials reported for an electroactive organic compound in neutral electrolytes. MMV, however, showed poor cycling performance at high concentrations. Signs of dimerization and precipitation were observed, resulting in measured capacities significantly lower than theoretical values and a rapid fade rate. It should be possible to avoid these problems by synthesizing asymmetric MMV derivatives with a higher charge to preserve high solubility and low redox potential.