27 July 2017 in Atmospheric Chemistry and Physics
Simultaneous air–sea fluxes and concentration differences of dimethylsulfide (DMS) and carbon dioxide (CO2) were measured during a summertime North Atlantic cruise in 2011. This data set reveals significant differences between the gas transfer velocities of these two gases (Δkw) over a range of wind speeds up to 21 m s−1. These differences occur at and above the approximate wind speed threshold when waves begin breaking. Whitecap fraction (a proxy for bubbles) was also measured and has a positive relationship with Δkw, consistent with enhanced bubble-mediated transfer of the less soluble CO2 relative to that of the more soluble DMS. However, the correlation of Δkw with whitecap fraction is no stronger than with wind speed. Models used to estimate bubble-mediated transfer from in situ whitecap fraction underpredict the observations, particularly at intermediate wind speeds. Examining the differences between gas transfer velocities of gases with different solubilities is a useful way to detect the impact of bubble-mediated exchange. More simultaneous gas transfer measurements of different solubility gases across a wide range of oceanic conditions are needed to understand the factors controlling the magnitude and scaling of bubble-mediated gas exchange.
15 May 2020 in Atmospheric Chemistry and Physics
Stable water isotopologues (SWIs) are useful tracers of moist diabatic processes in the atmospheric water cycle. They provide a framework to analyse moist processes on a range of timescales from large-scale moisture transport to cloud formation, precipitation and small-scale turbulent mixing. Laser spectrometric measurements on research vessels produce high-resolution time series of the variability of the water vapour isotopic composition in the marine boundary layer. In this study, we present a 5-month continuous time series of such ship-based measurements of δ2H and δ18O from the Antarctic Circumnavigation Expedition (ACE) in the Atlantic and the Southern Ocean in the time period from November 2016 to April 2017. We analyse the drivers of meridional SWI variations in the marine boundary layer across diverse climate zones in the Atlantic and Southern Ocean using Lagrangian moisture source diagnostics and relate vertical SWI differences to near-surface wind speed and ocean surface state. The median values of δ18O, δ2H and deuterium excess during ACE decrease continuously from low to high latitudes. These meridional SWI distributions reflect climatic conditions at the measurement and moisture source locations, such as air temperature, specific humidity and relative humidity with respect to sea surface temperature. The SWI variability at a given latitude is highest in the extratropics and polar regions with decreasing values equatorwards. This meridional distribution of SWI variability is explained by the variability in moisture source locations and its associated environmental conditions as well as transport processes. The westward-located moisture sources of water vapour in the extratropics are highly variable in extent and latitude due to the frequent passage of cyclones and thus widen the range of encountered SWI values in the marine boundary layer. Moisture loss during transport further contributes to the high SWI variability in the extratropics. In the subtropics and tropics, persistent anticyclones lead to well-confined narrow easterly moisture source regions, which is reflected in the weak SWI variability in these regions. Thus, the expected range of SWI signals at a given latitude strongly depends on the large-scale circulation. Furthermore, the ACE SWI time series recorded at 8.0 and 13.5 m above the ocean surface provide estimates of vertical SWI gradients in the lowermost marine boundary layer. On average, the vertical gradients with height found during ACE are for δ18O, for δ2H and 0.3 ‰ m−1 for deuterium excess. Careful calibration and post-processing of the SWI data and a detailed uncertainty analysis provide a solid basis for the presented gradients. Using sea spray concentrations and sea state conditions, we show that the vertical SWI gradients are particularly large during high wind speed conditions with increased contribution of sea spray evaporation or during low wind speed conditions due to weak vertical turbulent mixing. Although further SWI measurements at a higher vertical resolution are required to validate these findings, the simultaneous SWI measurements at several heights during ACE show the potential of SWIs as tracers for vertical mixing and sea spray evaporation in the lowermost marine boundary layer.
4 April 2014 in Atmospheric Chemistry and Physics
Eddy covariance measurements of air–sea CO2 fluxes can be affected by cross-sensitivities of the CO2 measurement to water vapour, resulting in order-of-magnitude biases. Well-established causes for these biases are (i) cross-sensitivity of the broadband non-dispersive infrared sensors due to band-broadening and spectral overlap (commercial sensors typically correct for this) and (ii) the effect of air density fluctuations (removed by determining the dry air CO2 mixing ratio). Another bias related to water vapour fluctuations has recently been observed with open-path sensors, attributed to sea salt build-up and water films on sensor optics. Two very different approaches have been used to deal with these water vapour-related biases. Miller et al. (2010) employed a membrane drier to physically eliminate 97% of the water vapour fluctuations in the sample air before it entered a closed-path gas analyser. Prytherch et al. (2010a) employed the empirical (Peter K. Taylor, PKT) post-processing correction to correct open-path sensor data. In this paper, we test these methods side by side using data from the Surface Ocean Aerosol Production (SOAP) experiment in the Southern Ocean. The air–sea CO2 flux was directly measured with four closed-path analysers, two of which were positioned down-stream of a membrane dryer. The CO2 fluxes from the two dried gas analysers matched each other and were in general agreement with common parameterisations. The flux estimates from the un-dried sensors agreed with the dried sensors only during periods with low latent heat flux (≤7 W m−2). When latent heat flux was higher, CO2 flux estimates from the un-dried sensors exhibited large scatter and an order-of-magnitude bias. Applying the PKT correction to the flux data from the un-dried analysers did not remove the bias when compared to the data from the dried gas analyser. The results of this study demonstrate the validity of measuring CO2 fluxes using a pre-dried air stream and show that the PKT correction is not valid for the correction of CO2 fluxes.
10 April 2017 in Journal of Geophysical Research: Oceans
9 June 2021 in Journal of Geophysical Research: Atmospheres
In this study, we investigate the occurrence of primary biological aerosol particles (PBAP) over all sectors of the Southern Ocean (SO) based on a 90‐day data set collected during the Antarctic Circumnavigation Expedition (ACE) in austral summer 2016–2017. Super‐micrometer PBAP (1–16 µm diameter) were measured by a wide band integrated bioaerosol sensor (WIBS‐4). Low (3σ) and high (9σ) fluorescence thresholds are used to obtain statistics on fluorescent and hyper‐fluorescent PBAP, respectively. Our focus is on data obtained over the pristine ocean, that is, more than 200 km away from land. The results indicate that (hyper‐)fluorescent PBAP are correlated to atmospheric variables associated with sea spray aerosol (SSA) particles (wind speed, total super‐micrometer aerosol number concentration, chloride and sodium concentrations). This suggests that a main source of PBAP over the SO is SSA. The median percentage contribution of fluorescent and hyper‐fluorescent PBAP to super‐micrometer SSA was 1.6% and 0.13%, respectively. We demonstrate that the fraction of (hyper‐)fluorescent PBAP to total super‐micrometer particles positively correlates with concentrations of bacteria and several taxa of pythoplankton measured in seawater, indicating that marine biota concentrations modulate the PBAP source flux. We investigate the fluorescent properties of (hyper‐)fluorescent PBAP for several events that occurred near land masses. We find that the fluorescence signal characteristics of particles near land is much more variable than over the pristine ocean. We conclude that the source and concentration of fluorescent PBAP over the open ocean is similar across all sampled sectors of the SO.
1 June 2015 in Journal of Atmospheric and Oceanic Technology
Ship-based measurements of wind speed and direct fluxes are affected by airflow distortion that can lead to a tilt of the wind vector as well as acceleration or deceleration of the wind speed. Direct flux measurements are additionally affected by the fluctuating velocity of the platform. The classic approach is to first correct the wind speed for angular and translational platform velocities and thereafter rotate the wind vector into the mean flow. This study finds that for ships under way, this leads to an overestimation of the vector tilt and biased flux estimates. This may explain the common observation that flux estimates from ships in transit have lower quality than measurements taken on station. Here an alternative approach is presented, where the flow-distortion-induced tilt of the wind vector is estimated from the 3D wind speed measurements and applied to the apparent wind vector. The tilt correction is carried out after correction for the fluctuating part of the platform velocity but before removing the ship’s mean translational velocity. This new method significantly improved the agreement of direct momentum flux measurements made from a ship under way with the parameterization of the COARE3.5 bulk model. The sensitivity of the eddy covariance measurements of momentum and scalar fluxes to the choice of the tilt-motion correction method is analyzed, and this study proposes that a reanalysis of previous direct flux measurements with the new method discussed here can improve researchers’ understanding of air–sea interaction.