1 September 2013 in Trends in Microbiology
SESteffen R. Eickhardt-Sørensen
Steffen R. Eickhardt-Sørensen
+2
1 December 2019 in Biofilm
The microtiter assay is one of the most widely used methods for assessing biofilm formation. Though it has high throughput, this assay is known for its substantial deviation from experiment to experiment, and even from well to well. Since the assay constitutes one of the pillars of biofilm research, it was decided to examine the wells of a microtiter plate directly during growth, treatment, and the steps involved in crystal violet (CV) measurements.
1 May 2017 in Applied and Environmental Microbiology
Alginate beads represent a simple and highly reproducible in vitro model system for diffusion-limited bacterial growth. In this study, alginate beads were inoculated with Pseudomonas aeruginosa and followed for up to 72 h. Confocal microscopy revealed that P. aeruginosa formed dense clusters similar in size to in vivo aggregates observed ex vivo in cystic fibrosis lungs and chronic wounds. Bacterial aggregates primarily grew in the bead periphery and decreased in size and abundance toward the center of the bead. Microsensor measurements showed that the O 2 concentration decreased rapidly and reached anoxia ∼100 μm below the alginate bead surface. This gradient was relieved in beads supplemented with NO 3 − as an alternative electron acceptor allowing for deeper growth into the beads. A comparison of gene expression profiles between planktonic and alginate-encapsulated P. aeruginosa confirmed that the bacteria experienced hypoxic and anoxic growth conditions. Furthermore, alginate-encapsulated P. aeruginosa exhibited a lower respiration rate than the planktonic counterpart and showed a high tolerance toward antibiotics. The inoculation and growth of P. aeruginosa in alginate beads represent a simple and flexible in vivo -like biofilm model system, wherein bacterial growth exhibits central features of in vivo biofilms. This was observed by the formation of small cell aggregates in a secondary matrix with O 2 -limited growth, which was alleviated by the addition of NO 3 − as an alternative electron acceptor, and by reduced respiration rates, as well as an enhanced tolerance to antibiotic treatment. IMPORTANCE Pseudomonas aeruginosa has been studied intensively for decades due to its involvement in chronic infections, such as cystic fibrosis and chronic wounds, where it forms biofilms. Much research has been dedicated to biofilm formation on surfaces; however, in chronic infections, most biofilms form small aggregates of cells not attached to a surface, but embedded in host material. In this study, bacteria were encapsulated in small alginate beads and formed aggregates similar to what is observed in chronic bacterial infections. Our findings show that aggregates are exposed to steep oxygen gradients, with zones of oxygen depletion, and that nitrate may serve as an alternative to oxygen, enabling growth in oxygen-depleted zones. This is important, as slow growth under low-oxygen conditions may render the bacteria tolerant toward antibiotics. This model provides an alternative to surface biofilm models and adds to the comprehension that biofilms do not depend on a surface for formation.
1 March 2018 in Applied and Environmental Microbiology
For the past 150 years, bacteria have been investigated primarily in liquid batch cultures. Contrary to most expectations, these cultures are not homogeneous mixtures of single-cell bacteria, because free-floating bacterial aggregates eventually develop in most liquid batch cultures. These aggregates share characteristics with biofilms, such as increased antibiotic tolerance. We investigated how aggregates develop and what influences this development in liquid batch cultures ofPseudomonas aeruginosa. We focused on how the method of inoculation affected aggregation by assessing aggregate frequency and size using confocal laser scanning microscopy. Several traditional methods of initiating an overnight bacterial culture, i.e., inoculation directly from frozen cultures, inoculation using agar-grown cells, or inoculation using cells grown in liquid cultures, were investigated. We discovered a direct link between the inoculation method and the size and frequency of biofilm aggregates in liquid batch cultures, with inoculation directly from a plate resulting in the most numerous and largest aggregates. These large aggregates had an overall impact on the cultures' subsequent tolerance toward tobramycin, indicating that the inoculation method has a profound impact on antibiotic tolerance. We also observed a mechanism whereby preformed aggregates recruited single cells from the surrounding culture in a “snowball effect,” building up aggregated biomass in the culture. This recruitment was found to rely heavily on the exopolysaccharide Psl. Additionally, we found that bothEscherichia coliandStaphylococcus aureusproduced aggregates in liquid batch cultures. Our results stress the importance of inoculation consistency throughout experiments and the substantial impact aggregate development in liquid batch cultures may have on the outcomes of microbiological experiments.IMPORTANCEPure liquid cultures are fundamental to the field of microbiological research. These cultures are normally thought of as homogeneous mixtures of single-cell bacteria; the present study shows that this is not always true. Bacteria may aggregate in these liquid cultures. The aggregation can be induced by the method chosen for inoculation. The presence of aggregates can significantly change the outcomes of experiments by altering the phenotype of the cultures. The study found a mechanism whereby preformed aggregates are able to recruit surrounding single cells in a form of snowball effect, creating more and larger aggregates in the cultures. Once formed, these aggregates are hard to remove. Aggregates in liquid cultures may be an immense unseen challenge for microbiologists.