Lingjiu Zhou

Lingjiu Zhou

Auto-generated profile, based on publicly available information

Lingjiu Zhou

College of Water Resources and Civil Engineering, China Agricultural University, Beijing, 100083, China

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 December 2007 in Journal of Fluids Engineering
Verified
Journal Article
Closed access
PDF file
LZLingjiu Zhou
Lingjiu Zhou
Wang ZhengweiWang Zhengwei
Wang Zhengwei
Cavitating flow around a hydrofoil was simulated using a transport equation-based model with consideration of the influence of noncondensable gases. The cavity length and the pressure distributions on the suction side can be well predicted for stable cavities using the standard renormalization-group (RNG) κ-ε turbulence model with proper noncondensable gas mass fraction. The unstable cavity shedding at lower cavitation numbers was not well predicted by the standard RNG κ-ε turbulence model. A modified RNG κ-ε turbulence model was evaluated by comparing the calculated spatial-temporal pressure distributions on the suction wall with experimental data. The results showed that the predicted cavity growth and shedding cycle and its frequency agree well with the experimental data. However, the pressure increase caused by interaction of the reentrant flow and the cavity interface is overestimated, which caused the time-averaged pressure on the front part of the hydrofoil to be overestimated. The time-averaged pressure on the rear of the hydrofoil was low because the small cavity shedding on the rear part of the cavity was not predicted.

20 December 2013 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
PDF file
JYJ Yang
J Yang
LZL J Zhou
L J Zhou
ZWZ W Wang
Z W Wang
FZF L Zhi
F L Zhi

20 December 2013 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
PDF file
MHM He
M He
QGQ Guo
Q Guo
LZL J Zhou
L J Zhou
ZWZ W Wang
Z W Wang
XWX Wang
X Wang
To seek a better numerical method to simulate the cavitating flow field in a centrifugal pump, the applications between RNG k- ε and LES turbulence model were compared by using the Zwart-Gerber-Belamri cavitation model. It was found that both the models give almost the same results with respect to pump performance and cavitation evolutions including growth, local contraction, stability and separation in the impeller passage. But the LES model can not only capture the pump suction recirculation and the low frequency fluctuation caused by it, but also combine the changes of the shaft frequency amplitude acting on the impeller with the cavitation unstable characteristics. Thus the LES model has more advantages than RNG k- ε model in calculating the unsteady cavitating flow in a centrifugal pump.

26 November 2012 in IOP Conference Series: Earth and Environmental Science
Verified
Conference Paper
Open access
PDF file
MHM He
M He
LFL P Fu
L P Fu
LZL J Zhou
L J Zhou
QGQ Guo
Q Guo
ZWZ W Wang
Z W Wang
Cavitation is a well-known problem in centrifugal pumps, causing serious damage and substantial head losses. However, the reason for the sudden head drop in cavitation curves is not fully understood. In this paper, the transient three-dimensional cavitating flow field in a centrifugal pump was calculated using RNG k-ε turbulence model and Rayleigh Plesset cavitation model. The NPSH-H curve and the cavitation development in the whole passage were predicted. The blade loading and energy transfer are analyzed for various cavitation conditions. The results show that the existing of the cavities changes the load distribution on blades. With the decrease of NPSH the loads on blades tend to increases in the rear part but decreases in the front part. If NPSH is not so low, sometimes the overall torque may increase slightly, thus the head may also increase slightly. But if the NPSH become low and reach a threshold value, the overall torque will also decrease. At the same time, the energy dissipation in the vortices increases greatly because of the growth of the cavities. These two reasons make the head drop rapidly.

20 December 2013 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
PDF file
QGQ Guo
Q Guo
LZL J Zhou
L J Zhou
YXY X Xiao
Y X Xiao
ZWZ W Wang
Z W Wang
As a renewable energy, marine currents get more and more attention. Thus the development of marine current turbines is critical to the use of this energy. We use large-eddy simulation to analyse the flow field characteristics by full geometry of a horizontal axis marine current turbine. Under the effect of a discrete number of blades, blade tip vortices develop and produce velocity variation near rotor. Referring to the flow induction factors in BEM theory, this paper focuses on the study of axial and tangential velocity and it is found that the main induced velocity component by the vortices is axial velocity. According to the distribution of the two velocity components along circumferential orientation, three peak-valley values corresponding to the number of blades reflect the flow non-uniformity due to the effect of a discrete number of blades even for the upstream of rotor. Meanwhile, this effect will continue developing due to the analysis of flow characteristics in the downstream field.

20 December 2013 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
PDF file
BXB Y Xiao
B Y Xiao
LZL J Zhou
L J Zhou
YXY X Xiao
Y X Xiao
ZWZ W Wang
Z W Wang
Nowadays tidal current energy is considered to be one of the most promising alternative green energy resources and tidal current turbines are used for power generation. Prediction of the open water performance around tidal turbines is important for the reason that it can give some advice on installation and array of tidal current turbines. This paper presents numerical computations of tidal current turbines by using a numerical model which is constructed to simulate an isolated turbine. This paper aims at studying the installation of marine current turbine of which the hydro-environmental impacts influence by means of numerical simulation. Such impacts include free-stream velocity magnitude, seabed and inflow direction of velocity. The results of the open water performance prediction show that the power output and efficiency of marine current turbine varies from different marine environments. The velocity distribution should be clearly and the suitable unit installation depth and direction be clearly chosen, which can ensure the most effective strategy for energy capture before installing the marine current turbine. The findings of this paper are expected to be beneficial in developing tidal current turbines and array in the future.