We present the demonstration of an integrated Frequency Modulated Continuous Wave LiDAR on a silicon platform. The waveform calibration, the scanning system and the balanced detectors are implemented on chip. Detection and ranging of a moving hard target at up to 60 m with less than 5 mW of output power is demonstrated here.
20 November 2017 in Journal of Lightwave Technology
Transceivers based on electroabsorption modulators (EAM) are considered as a promising candidate for the next generation 400 GbE short-reach optical networks. They are capable of combining high bandwidth and low-power operation with a very compact layout, removing the need for traveling wave electrodes and dedicated 50 Ω termination. In this paper, we demonstrate the first silicon-based EAM, in combination with an in-house developed SiGe BiCMOS transceiver chipset, capable of transmitting single-lane 100 Gb/s non-return-to-zero in real-time. Transmission over 500 m of standard single mode fiber and 2 km of nonzero dispersion shifted fiber is demonstrated, assuming a forward-error coding scheme is used with a bit-error ratio limit of 3.8 × 10 -3 . Due to the high line rate, transmission over longer fiber spans was limited by the chromatic distortion in the fiber. As a possible solution, electrical duobinary modulation is proposed as it is more resilient to this type of fiber distortion by reducing the required optical bandwidth. We show improved performance for longer fiber spans with a 100 Gb/s electrical duobinary link, resulting in realtime sub-forward error coding operation over more than 2 km of standard single-mode fiber without any digital signal processing. Finally, the possibility of a 100 Gb/s EAM-to-EAM link is investigated.
We report the design and experiment of advanced bends which are composed of widening width and varying radius. Advanced bends are based on silicon nitride waveguide for the wavelength of 850nm and silicon waveguide for the wavelength of 1550nm. The reduction of bending loss from 0.13 to 0.04dB/90° by the advanced shape on a silicon nitride waveguide bend with 15μm-radius at the wavelength of 850nm was achieved. The bending loss from the silicon advanced bend was measured to be 0.012dB/90° when R=2μm at the wavelength of 1550nm. This is the best result of 2μm-bends in a 220nm-SOI platform at 1550nm.
We report a silicon-contacted Ge/Si avalanche photodiode with RF gain of 11 and a bandwidth of 27 GHz at -12 V operating at 1310 nm. The device is fabricated in an established Si photonics platform without additional process complexity and contacts only on Si. Wafer-scale performance data are presented confirming the reproducibility and the manufacturability of the device. Wide open eye diagrams are demonstrated for 25, 40 and 50 Gbps data-rates. The demonstration of such avalanche photodiode shows great potential for improving optical link margins for optical transceivers operating at 400 Gb/s and beyond.
19 February 2019 in Journal of Lightwave Technology
We present a 70 Gb/s capable optical transmitter consisting of a 50 μm long GeSi electro-absorption modulator (integrated in Silicon Photonics) and a fully differential driver designed in a 55 nm SiGe BiCMOS technology. By properly unbalancing the output stage, the driver can be DC-coupled to the modulator thus avoiding the use of on-chip or external bias-Ts. At a wavelength of 1560 nm, open eye diagrams for 70 Gb/s after transmission over 2 km standard single-mode fiber were demonstrated. The total power consumption is 61 mW, corresponding to 0.87 pJ/bit at 70 Gb/s. Bit-error rate measurements at 50 Gb/s and 56 Gb/s (performed both back-to-back and with up to 2km standard single-mode fiber) demonstrate large (0.4 UI at a BER of $10^{-12}$ ) horizontal eye margins. This optical transmitter is ideally suited for datacenter applications which require densely integrated transceivers with a low power consumption.
3 February 2019 in Journal of Lightwave Technology
With next-generation optical interconnects for data centers aiming for 0.8 Tb/s or 1.6 Tb/s, 100 Gbaud capable transmitters from a single-laser source will become indispensable. However, these lane rates would require bandwidths of 70 GHz or more, doubling the bandwidth requirements of the electrical and optical components with respect to the fastest current generation of optical interconnects running at 53 Gbaud pulse-amplitude modulation (PAM-4). In this paper, we propose an integrated 4:1 optical serializer topology to achieve 104 Gbaud On-Off Keying (OOK) and PAM-4 transmission using only quarter rate components at the transmitter. We show 104 (208) Gbit/s OOK (PAM4) transmission using four GeSi electro-absorption modulators (EAMs) over 1 km of single-mode fiber (SMF). For 104 Gbaud OOK, clearly open eyes are obtained, while for PAM-4 the performance is limited by the nonlinear E/O-transfer function of the EAM. However, adding pre-emphasis in the electrical driver or replacing the single EAM with our previously demonstrated optical DAC topology-consisting of two EAMs in parallel with a 90° phase difference between each-could substantially improve these results. Additionally, we discuss the possibility of a four channel transmitter (4 × 208 Gb/s) from a single mode locked laser, amounting to a 832 Gb/s rate based on the current demonstrator.