Nobuhiko Miki

Nobuhiko Miki

Auto-generated profile, based on publicly available information

Nobuhiko Miki

Ritsumeikan University,Dept. of Electronic and Computer Engineering,Kusatsu, Shiga,Japan,525-8577

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 February 2022 in IEEE Access
Verified
Journal Article
Open access
IMIssei Makino
Issei Makino
ZWZhao Wang
Zhao Wang
JTJunji Terai
Junji Terai
NMNobuhiko Miki
Nobuhiko Miki
The private LTE/5G networks are now getting a lot of attention since it can offer a secure and flexible indoor network such as smart factories and buildings by the cellular-based technologies. However, the cell planning and physical layer parameter optimization to achieve the wide indoor coverage and low latency, which are important performance in such deployments, remain very important and difficult issues to be solved. Therefore, this paper measures the reference signal received power (RSRP), throughput, and delay performance with the shared extended global platform (sXGP) system following TD-LTE specification employing the 1.9 GHz band with 5 MHz bandwidth in the multi-floor building. We employ the automated guided vehicle (AGV), which enables highly accurate measurements while moving at walking speed. We measure the indoor spatial distribution of the performance under various conditions, such as opening and closing of doors and human blockage. Since the delay performance depends more on the physical layer procedure and parameter settings such as scheduling request (SR) periodicity than on the channel conditions, we evaluate the influence of the SR periodicity on the delay performance, and analyze the physical layer procedure in detail. We estimate the delay based on the analysis, and show that the estimated and the measured delays are in good agreement.

1 January 2013 in IEICE Transactions on Communications
Verified
Journal Article
Closed access
MJMoo Ryong Jeong
Moo Ryong Jeong
NMNobuhiko Miki
Nobuhiko Miki

27 January 2023 in IEEE Access
Verified
Journal Article
Open access
IMIssei Makino
Issei Makino
NMNobuhiko Miki
Nobuhiko Miki
Indoor private (local) wireless networks are considered key enablers for the industrial Internet of Things (IIoT). To ensure that a private network satisfies its own requirements and guarantees coverage, it is important to accurately measure the radio performance at the accurate position to further optimize the network. Additionally, as carrier frequencies increase, cellular network-based positioning becomes increasingly important, as it enables more accurate positioning. For example, centimeter-level accuracy is expected in beyond 5G systems owing to the sub-THz band carrier frequency. To accurately compare and assess various cellular network-based positioning methods, positioning devices, which can move along the same trajectory more accurately than at the centimeter-level, are required. To this end, we implemented a three-dimensional (3D) positioning device developed from open-source hardware, which is generally used to implement computer numerical control (CNC) machines and 3D printers. The implemented 3D pointing device is cost-effective and portable and can be freely configurable and resized in one, two, and three dimensions owing to the use of open-source hardware. The received signal strength indicator (RSSI) employing the LoRa module can be obtained using the implemented device. Using a very low carrier frequency system, it is possible to accurately measure the RSSI variations due to multipath propagation. After demonstrating the reproducibility of the data, the effectiveness of the implemented device was confirmed by showing that the RSSI variation and fading correlation coefficient are close to the Rayleigh fading variation.

1 December 2019
Verified
Conference Paper
Closed access
NMNobuhiko Miki
Nobuhiko Miki
SSSatoshi Suyama
Satoshi Suyama
SNSatoshi Nagata
Satoshi Nagata
This paper evaluates the performance degradation incurred by an approximation algorithm (min-sum algorithm) when polar codes under successive cancellation decoding (SCD) are employed. To understand the behavior of the algorithm under the SCD, the error performances of the synthetic channels were evaluated, since different synthetic channels show different levels of degradation, because the numbers of the approximation algorithm applied to the channels and the operating signal-to-noise power ratios (SNRs) of the channels, which also affect the levels of degradation, are different. After evaluation of the synthetic channels, the block error rate performances under the SCD for different coding rates were obtained. The results show that the performance degradation was not significant, even when a coded bit length of $2^{14}=16384$ was used.

1 July 2026 in IEICE Communications Express
Verified
Journal Article
Closed access
YNYuto Nakamura
Yuto Nakamura
NMNobuhiko Miki
Nobuhiko Miki
SSSatoshi Suyama
Satoshi Suyama
SNSatoshi Nagata
Satoshi Nagata
This paper investigates a low-latency decoding approach for convolutional polar codes using a neural network decoder (NND). Although NNDs enable one-shot decoding and significantly reduce latency, their error-rate performance can be further improved. To address this issue' we introduce a training strategy combining importance sampling, a ResNet-based architecture, and ensemble learning. Simulation results obtained using a convolutional polar code and an NND over an AWGN channel are presented. The proposed NND achieves stepwise improvements in BER compared with a conventional NND baseline, while preserving low decoding latency.

2 January 2003
Verified
Conference Paper
Closed access
XCXixian Chen
Xixian Chen
MSMasato Suzuki
Masato Suzuki
NMN. Miki
N. Miki
NNN. Nagai
N. Nagai
The authors present a new scheme that extends the correlation based fast training of echo cancellers introduced by Long and Ling (1990) to allow for ultra-high-speed initialization of a full-duplex data transmission system over two-wire lines. A fast training procedure is derived to coestimate the near echo and the far echo with bulk delay, and the channel responses. The effects of the noise and symbol rates' offset between two ends are examined in terms of both mean square error and SNR. Both the theoretical analysis and computer simulations show that there are three degrading factors due to symbol rates' offset. The new algorithm delivers fst convergence speed with the same computational requirements as those of stochastic-gradient algorithms and reduces the tap-setting time to half of that required by the traditional half-duplex fast training scheme.