7 November 2017 in Scientific Reports
Due to their mechanical and physical properties, aluminium alloys possess wide potential in the automotive industry, particularly in hot reciprocating applications such as pistons for diesel and petrol engines. WS2 particle-reinforced composites could bring further improvements by reducing friction and wear between moving parts. Reducing friction improves efficiency by lowering energy/fuel use, ultimately leading to lower greenhouse gas emissions, while antiwear properties can prolong component life. This study compares for the first time the tribological performance of powder metallurgy-consolidated Al composites reinforced with either IF- or 2H-WS2 particles, so as to elucidate their mechanism of action in test conditions similar to those encountered in engine applications. The composites were tested in lubricated reciprocating contacts against AISI52100 steel balls and the impact of WS2 could be seen at both 25 and 100 °C. The reduced friction and wear at ambient temperature is due to the predominantly physical mechanism of action of WS2, while the best antiwear performance is measured at elevated (standard operating engine) temperatures that promote the chemical reaction of WS2 with the aluminium matrix. The investigation focused on studying the wear tracks/scars and the tribofilms generated on the composite and ball with optical profilometry, SEM, XPS and Auger spectroscopy.
6 June 2017 in Tribology Letters
12 June 2018 in Tribology Transactions
High-strength steels are particularly susceptible to hydrogen embrittlement and therefore rolling element bearings can experience premature failure that drastically reduces their operation life. Some lubricant additives can prevent this by generating protective tribofilms during operation. This study investigates the effect of temperature on the growth of zinc dialkyl dithiophosphate (ZDDP)-generated tribofilms and the relationship with the permeation of hydrogen in the substrate. Rolling contact tests were conducted using ZDDP at 333, 363, and 393 K and the concentration of hydrogen was measured after the tests. It was found that low temperatures inhibit the reactivity of the additive, leading to an inadequate coverage of the surface that allows dissociation and permeation of hydrogen in the sample. Higher temperatures induce uniform films in the contact, although excessive temperatures can promote unnecessary wear of the substrate. An optimum temperature can balance the two main processes occurring in the contact related to the reactivity of the additive: the growth of a protective film and the corrosive wear of the material.