18 September 2018 in IEEE Transactions on Nanobioscience
Although many exciting applications of molecular communication (MC) systems are envisioned to be at microscale, the MC testbeds reported in the literature so far are mostly at macroscale. This may partially be due to the fact that controlling an MC system at microscale is challenging. To link the macroworld to the microworld, we propose and demonstrate a biological signal conversion interface that can also be seen as a microscale modulator. In particular, the proposed interface transduces an optical signal, which is controlled using a lightemitting diode (LED), into a chemical signal by changing the pH of the environment. The modulator is realized using Escherichia coli bacteria as microscale entity expressing the light-driven proton pump gloeorhodopsin from Gloeobacter violaceus. Upon inducing external light stimuli, these bacteria locally change their surrounding pH level by exporting protons into the environment. To verify the effectiveness of the proposed optical-to-chemical signal converter, we analyze the pH signal measured by a pH sensor, which serves as receiver. We develop an analytical parametric model for the induced chemical signal as a function of the applied optical signal. Using this model, we derive a trainingbased channel estimator which estimates the parameters of the proposed model to fit the measurement data based on a least square error approach. We further derive the optimal maximum likelihood detector and a suboptimal low-complexity detector to recover the transmitted data from the measured received signal. It is shown that the proposed parametric model is in good agreement with the measurement data. Moreover, for an example scenario, we show that the proposed setup is able to successfully convert an optical signal representing a sequence of binary symbols into a chemical signal with a bit rate of 1 bit/min and recover the transmitted data from the chemical signal using the proposed estimation and detection schemes. The proposed modulator may form the basis for future MC testbeds and applications at microscale.
2 February 2023 in IEEE Microwave Magazine
Most RF and millimeter-wave systems for communications and radar include at least one transmitter used to up-convert, amplify, and potentially radiate the desired signal without distortion. Moreover, this part of the system, and in particular its power amplifier (PA), does typically dominate the total power consumption of electronic infrastructure systems. Thus, increasing the PA’s efficiency is the most effective way to enhance the overall power efficiency of such systems.