Knowledge of the optical properties of soot black carbon (BC) is required for the prediction of the radiative effects of freshly-emitted and aged BC particles. Here we review BC mass absorption cross section (MAC) and absorption function E(m) measurements, focussing on freshly-emitted BC. First, we review recently reported MACs at 550 nm wavelength as obtained from direct measurements of particulate absorption and mass concentration; we find an average of 8.0 ± 0.7 m2/g from ten measurements, not significantly higher (p > 0.26) than the widely used MAC of 7.5 ± 1.2 m2/g recommended by Bond and Bergstrom (2006). Second, we review recently reported E(m), whose retrieval is more complex due to the need to combine measurements with numerical models to estimate the contribution of scattering to extinction. Third, we review recent numerical studies that have aimed to predict the BC MAC using various complex refractive indices (m = n + ik). Most of these studies have used m = 1.95 + 0.79i recommended by Bond and Bergstrom (2006), yet failed to predict a MAC as high as 7.5 or 8.0 m2/g at 550 nm wavelength. Fourth, we summarize a selected range of alternative values of m that have been reported by recent studies and place them in the context of measurements using a contour plot of E(m) on the n–k plane. We show that the widely used m = 1.95 + 0.79i corresponds to an E(m) that is too low to be consistent with the measured MAC values. We conclude that the E(m) of BC in the visible and near infrared should be greater than 0.32, and that the commonly used BC models or the refractive index, or both, are still in need of improvement.
Ship engines in the open ocean and Arctic typically combust heavy fuel oil (HFO), resulting in light-absorbing particulate matter (PM) emissions that have been attributed to black carbon (BC) and conventional, soluble brown carbon (brC). We show here that neither BC nor soluble brC is the major light-absorbing carbon (LAC) species in HFO-combustion PM. Instead, “tar brC” dominates. This tar brC, previously identified only in open-biomass-burning emissions, shares key defining properties with BC: it is insoluble, refractory, and substantially absorbs visible and near-infrared light. Relative to BC, tar brC has a higher Angstrom absorption exponent (AAE) (2.5–6, depending on the considered wavelengths), a moderately-high mass absorption efficiency (up to 50% of that of BC), and a lower ratio of sp2- to sp3-bonded carbon. Based on our results, we present a refined classification of atmospheric LAC into two sub-types of BC and two sub-types of brC. We apply this refined classification to demonstrate that common analytical techniques for BC must be interpreted with care when applied to tar-containing aerosols. The global significance of our results is indicated by field observations which suggest that tar brC already contributes to Arctic snow darkening, an effect which may be magnified over upcoming decades as Arctic shipping continues to intensify.
15 November 2011 in Environmental Science & Technology
This study reports the first of a kind data on aircraft engine non-volatile particulate matter (nvPM) number- and mass-based emissions using standardized systems. Two compliant sampling and measurement systems operated by Missouri University of Science and Technology (Missouri S&T) and Empa were evaluated during the Aviation - Particle Regulatory Instrumentation Demonstration Experiment (A-PRIDE) 4 campaign at the SR Technics facilities in Z\ufcrich, Switzerland, in November 2012. The Missouri S&T and Empa systems were compared during a series of dedicated engine tests using a CFM56-5B4/2P engine source, and maintenance engine testing using CFM56-7B24/3 and PW4168A engine sources at a range of engine operating conditions. These two compliant systems were found to agree within 6% of each other in terms of nvPM number-based emissions, and within 15% for nvPM mass-based emissions. For the three engine sources studied, at several engine power conditions the mass instruments approached their limit of detection, resulting in high measurement uncertainties. Ancillary instrumentation was used to determine PM size distributions, chemical composition, and effective density from mass-mobility experiments. Particle geometric mean mobility diameter ranged 20\u201345 nm, and geometric standard deviation varied from 1.55 to 1.9 for the three engine types studied. The fraction of PM organic content measured in the emissions from the CFM56-5B4/2P engine was \u223c4% while the size-dependent particle effective density was parameterized with a mass-mobility exponent of 2.57 and a pre-factor of 0.606. Results of this study will contribute to the development of the new nvPM emissions certification standard and emissions inventories from commercial aviation operations.Peer reviewed: YesNRC publication: Ye
13 February 2008 in Environmental Science & Technology