Andrew E. Johnson

Andrew E. Johnson

Auto-generated profile, based on publicly available information

Andrew E. Johnson

NASA Jet Propulsion Laboratory

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2008 in 2008 IEEE Aerospace Conference
Verified
Conference Paper
Closed access
AJAndrew E. Johnson
Andrew E. Johnson
JMJames F. Montgomery
James F. Montgomery
The driving precision landing requirement for the Autonomous Landing and Hazard Avoidance Technology project is to autonomously land within 100 m of a predetermined location on the lunar surface. Traditional lunar landing approaches based on inertial sensing do not have the navigational precision to meet this requirement. The purpose of Terrain Relative Navigation (TRN) is to augment inertial navigation by providing position or bearing measurements relative to known surface landmarks. From these measurements, the navigational precision can be reduced to a level that meets the 100 m requirement. There are three different TRN functions: global position estimation, local position estimation and velocity estimation. These functions can be achieved with active range sensing or passive imaging. This paper gives a survey of many TRN approaches and then presents some high fidelity simulation results for contour matching and area correlation approaches to TRN using active sensors. Since TRN requires an a-priori reference map, the paper concludes by describing past and future lunar imaging and digital elevation map data sets available for this purpose.

1 March 2008 in 2008 IEEE Aerospace Conference
Verified
Conference Paper
Closed access
AJAndrew E. Johnson
Andrew E. Johnson
AHAndres Huertas
Andres Huertas
RWRobert A. Werner
Robert A. Werner
JMJames F. Montgomery
James F. Montgomery
Landing hazard detection and avoidance technology is being pursued within NASA to improve landing safety and increase access to sites of interest on the lunar surface. The performance of a hazard detection and avoidance system depends on properties of the terrain, sensor performance, algorithm design, vehicle characteristics and the overall all guidance navigation and control architecture. This paper analyzes the size of the region that must be imaged, sensor performance parameters and the impact of trajectory angle on hazard detection performance. The analysis shows that vehicle hazard tolerance is the driving parameter for hazard detection system design.

1 April 2023 in Journal of Guidance, Control, and Dynamics
Verified
Journal Article
Closed access
AJAndrew E. Johnson
Andrew E. Johnson
YCYang Cheng
Yang Cheng
NTNikolas Trawny
Nikolas Trawny
JMJames F. Montgomery
James F. Montgomery
SSSteven Schroeder
Steven Schroeder
SMSwati Mohan
Swati Mohan
The Mars 2020 Entry, Descent, and Landing (EDL) system successfully delivered the Perseverance rover to Jezero Crater, the most hazardous landing site ever attempted on Mars. To mitigate the risk of landing hazards, which included cliffs, inescapable dune fields, and rocks, a novel terrain relative navigation system was developed and integrated with the heritage Mars Science Laboratory EDL system. First the hazards were identified using orbital imagery and stored on-board the spacecraft as a hazard map. Then, during parachute descent, the Lander Vision System (LVS) estimated map relative position by fusing landmarks matched between descent imagery and a map of the landing site with inertial measurement unit data. Finally, the position estimate and hazard map were then used by the powered descent system to identify and then fly to the safest and reachable landing target. Postflight analysis indicated that all required systems worked much better than predicted. In particular, the fully autonomous LVS generated a position estimate in 10 s that was in error by only a few meters relative to a 40 m requirement. This paper describes the LVS design, how it was tested before launch, and the LVS performance during EDL.

1 March 2006 in Journal of Field Robotics
Verified
Journal Article
Closed access
PDF file
JMJames F. Montgomery
James F. Montgomery
AJAndrew E. Johnson
Andrew E. Johnson
SRStergios I. Roumeliotis
Stergios I. Roumeliotis
LMLarry H. Matthies
Larry H. Matthies

3 January 2022
Verified
Conference Paper
Closed access
AJAndrew E. Johnson
Andrew E. Johnson
SASeth B. Aaron
Seth B. Aaron
HAHomayoon Ansari
Homayoon Ansari
CBCharles Bergh
Charles Bergh
HBHelene Bourdu
Helene Bourdu
SPSam Pedrotty
Sam Pedrotty
View Video Presentation: https://doi.org/10.2514/6.2022-1214.vid The Mars 2020 Entry Descent and Landing (EDL) system delivered the Perseverance rover to the surface of Mars on February 18th, 2021. A large fraction of the Jezero Crater landing site was covered with landing hazards including cliffs, inescapable dune fields and rocks. These hazards were identified or inferred using orbital imagery before launch so that they could be avoided using Terrain Relative Navigation (TRN) which was composed of two parts: the Lander Vision System (LVS) and Safe Target Selection (STS). During EDL, the LVS successfully estimated map relative position by fusing landmarks matched between descent imagery and a map of the landing site with Inertial Measurement Unit (IMU) data. This position estimate was used by STS to identify the safest target for landing that was also reachable given fuel and other constraints. The EDL system then used the powered descent phase to retarget to this location and land safely. The overall error between the targeted location and actual landing location was 5m which was an order of magnitude less than the 60m touchdown error requirement. This paper will describe the final tests of the LVS before launch, the checkout of the LVS during operations and the LVS performance during EDL.

11 August 2021 in Earth and Space Science
Verified
Journal Article
Open access
PDF file
YCYang Cheng
Yang Cheng
AAAdnan Ansar
Adnan Ansar
AJAndrew Johnson
Andrew Johnson
The Mars 2020 rover, Perseverance, landed in Jezero crater (18.4663oN, 77.4298oE) on February 18, 2021 to collect samples from Mars that could be returned to Earth by a future Mars Sample Return campaign. While providing a rich sampling opportunity, Jezero also contains numerous landing hazards including scarps, canyons, mesas, dune fields, rock fields and smaller craters. The Mars 2020 onboard inertial navigation system, which is the same as that used by the Mars Science Laboratory (MSL), only provides a very coarse inertially propagated position, which can have error as large as 3.2km. The Lander Vision System (LVS) was added to Mars 2020 to reduce this position knowledge error to less than 40m with respect to an on-board reference map of the landing area. LVS uses a reference map on board to compare with the descent images for lander localization during the terminal stage of EDL. Because the reference map is used directly during EDL, it is critical that it have as little spatial and photometric error as possible. Photometrically, it should resemble as much as possible the real descent images to allow reliable terrain matching. Spatially, it should match as faithfully as possible the real, underlying terrain and contribute minimal error to the final localization solution. On February 18, 2021, the LVS reference map passed its ultimate test. The LVS system executed Terrain Relative Navigation (TRN) flawlessly based on the LVS reference map. In addition to its use for TRN, the local hazard map is also registered to the LVS reference map so that the safe target selection (STS) system can select a safe and reachable landing site. The final error between the site targeted by the STS system and the real landing site is estimated at only 5 meters. The exceptional performance of LVS indicates that the reference map met mission requirements with comfortable margin. LVS on Mars 2020 represents the first ever use of a reference map during spacecraft EDL. This breakthrough will have profound implications for future lander missions and the scope of scientific inquiry they are able to address. In this paper, we will describe the necessary precursor steps to building the Jezero Crater LVS map, including the methodology to dejitter CTX images, improve the CTX sensor model, as well as the process used to validate the LVS map accuracy.