B. Ya. Trofimov

B. Ya. Trofimov

Auto-generated profile, based on publicly available information

B. Ya. Trofimov

South Ural State University, 454080 Chelyabinsk, Russia

Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2016 in Procedia Engineering
Verified
Journal Article
Open access
KSK.V. Schuldyakov
K.V. Schuldyakov
LKL.YA. Kramar
L.YA. Kramar
BTB.YA. Trofimov
B.YA. Trofimov
A ground blast-furnace granulated slag used in the production of construction materials and items differs in its chemical composition, dispersion, the quantity of amorphous phase and so on, which leads to the change of properties of the blended cement consisted of CEM I and supplemented with different amount of slag. The chemical and mineralogical composition of portland cement, the conditions of its maturing, activators and others also influence on the properties of the blended cement. The acid slag is not binding in contrast to the basic one, but due to the pozzolanic properties it interacts with the calcium hydroxide to form an additional amount of a low-basic hydrated calcium silicate in a hardened cement paste structure. The strength of the blended cement with increasing dosages of slag varies in different ways - small amount of slag in the cement even increases slightly the compressive and flexural strength in comparison with the blended cement without an additional CEM I. Increasing the dosage of slag in the blended cement, its compressive strength decreases slightly, especially at an early stage, and the flexural strength remains at the same level by increasing the dosage up to 70-80% of blended cement slag mass. Besides the CEM I dilution effect, the increase of the mixture water demand with the increased slag dosage influences the strength of mortar samples of equally and easily workable mixtures. A true water-binder ratio is increased significantly if the content of slag is over 70%.The conducted studies have shown that the substitution of CEM I with 70% of slag is optimal both from the perspective of the impact on the technical characteristics of the resulting rock and from the economic point of view.The rock structure obtained from the blended cement differs in terms of high concentration of amorphized low-basic hydration products and the decrease in its content of Са(ОН)2. The last is proportional to the number of slag additive and affects significantly the phase composition of the rock and its properties

1 January 2017 in Procedia Engineering
Verified
Journal Article
Open access
RYR.A. Yanturina
R.A. Yanturina
BTB.YA. Trofimov
B.YA. Trofimov
RAR.M. Ahmedjanov
R.M. Ahmedjanov

1 January 2016 in AIP Conference Proceedings
Verified
Conference Paper
Closed access
KSKirill Shuldyakov
Kirill Shuldyakov
LKLyudmila Kramar
Lyudmila Kramar
BTBoris Trofimov
Boris Trofimov
IIIlya Ivanov
Ilya Ivanov
Article presents the results of studies of various types of superplasticizer additives and their influence on concrete structure and resistance under cyclic freezing-thawing. Glenium ACE 430 was taken as a polycarboxylate superplasticizer, and SP-1 – as a naphthalene-formaldehyde superplasticizer. It is revealed that at identical structure, W/C and fluidity of concrete mix, application of the polycarboxylate superplasticizer, Glenium AC 430, in comparison to the naphthalene-formaldehyde one SP-1, facilitates the increase of the concrete grade in freeze and thaw resistance from F2300 to F2400, concrete freeze and thaw resistance can be possible even higher if the gravel with higher freeze and thaw resistance is applied. To assess the superplasticizers influence on cement paste structure tests of the phase composition of the cement paste of the studied concrete were conducted. It is established that the use of polycarboxylate superplasticizer together with silica fume facilitates formation of cement plaster structure from tobermorite gel. This gel has increased basicity and is resistant to crystallization due to cyclic freezing. It is shown that in the presence of SP-1+SF in the cement paste of concrete during hydration the structure of hydrosilicate phases preferably comprises of C-S-H(I) and C-S-H(II) phases which actively crystallize while cyclic freezing and thawing and reduce freeze-thaw resistance of concrete.

1 April 2013 in Magazine of Civil Engineering
Verified
Journal Article
Closed access
TCT.N. Chernykh
T.N. Chernykh
Aleksandr OrlovAleksandr Orlov
Aleksandr Orlov
LKL.Y. Kramar
L.Y. Kramar
BTB.Y. Trofimov
B.Y. Trofimov
APA.V. Perminov
A.V. Perminov
The article considers the problem of reducing the energy consumption during the production process of magnesia cement based on brucite admixed with serpentine, because this solid requires roasting at high temperatures (1100–1200°C). It was demonstrated that the most effective way to increase the energy efficiency of the technology is to use additives, so that roasting intensifiers. We investigated the effect of various additives and intensifiers to reduce the roasting temperature of serpentinized brucite material. We found that the most effective additives are those, destabilizing a crystal lattice of roasted solid and simultaneously producing the hot melt during their dehydration. It was shown that the highest temperature can be reduced by 100–300°C without increasing the heat treatment time. We also estimated the quality of magnesia cement obtained by the developed method and confirmed its compliance with all relevant regulations

1 January 2017 in AIP Conference Proceedings
Verified
Conference Paper
Closed access
GAG. F. Averina
G. F. Averina
TCT. N. Chernykh
T. N. Chernykh
LKL. Y. Kramar
L. Y. Kramar
BTB. Y. Trofimov
B. Y. Trofimov

1 January 2017 in Procedia Engineering
Verified
Journal Article
Open access
KSK.V. Schuldyakov
K.V. Schuldyakov
LKL.Ya. Kramar
L.Ya. Kramar
BTB.Ya. Trofimov
B.Ya. Trofimov