Hierarchical TiO2 microspheres assembled by nanospindles were prepared via a two-step hydrothermal method. The as-prepared products have uniform diameters of ∼450 nm and surface area of ∼88 m2 g−1. The optical investigation evidenced that the photoanode film has a prominent light scattering effect at a wavelength range of 600–800 nm and possesses enhanced dye loading capacity. In addition, the electron recombination and transport dynamic measurements indicated that these hierarchical products could suppress the recombination and improve the diffusion coefficient of the photoelectrons, which can be attributed to the improvement of the connectivity by bridging the neighbouring microspheres through the embedded nanospindles. As a result, a high power conversion efficiency of 8.5% was demonstrated, indicating a ∼30% improvement compared with the cell derived from the well-defined nanocrystalline microspheres (6.5%).
13 October 2015 in Physical Chemistry Chemical Physics
Grain boundary trap passivation in perovskite films has become one of the most effective strategies for suppressing the charge recombination and enhancing the photovoltaic performance of perovskite solar cells, whereas the relevant trap-state properties and the charge carrier dynamics need to be further clarified. In this work, the CH3NH3Cl (MACl) additive is introduced into the MAI:PbI2 precursor solution to obtain perovskite films comprising various grain sizes with distinct grain boundaries and trap-state properties. The influence of grain boundary traps passivated with the MACl additive on trap-state properties and charge carrier transport/recombination dynamics is systematically studied with time-resolved spectroscopic and transient photoelectric characterization. Specifically, the MACl amount determines the content of the PbI2 residual in the final perovskite, leading to photoluminescence quenching induced by charge transfer. The trap-state distribution result reveals that the deep-level traps at the grain boundaries as the main sources of charge recombination centers are dramatically passivated. Low-temperature photoluminescence spectroscopy distinguishes and compares the trap-state emission related to different perovskite phases. Transient photoelectric measurements including photovoltage decay and charge extraction further demonstrate that the boundary trap passivation can effectively promote charge transport and inhibit charge recombination in devices treated with the optimized MACl amount. As a result, the corresponding device possesses superior photovoltaic parameters to the control device. This work proposes a systematic understanding of the grain boundary trap passivation strategy and provides a new insight into the development of high-performance perovskite solar cells.
15 December 2017 in The Journal of Physical Chemistry C
We developed a two-step hydrothermal method to prepare hetero-structured TiO2 nanotree arrays on FTO substrates. This process included the deposition of rutile nanorod arrays with a length of about 2 μm as trunks at first and then the growth of the anatase nanosheets with the thickness of less than 10 nm standing on the rutile trunks through a dissolution-growth process. After being coated with CdS and CdSe quantum dots, these nanotrees were used as photoanodes in the quantum dot-sensitized solar cells (QDSSCs). It was found that the branches could enlarge the surface area of the anode, increase the amount of the deposited quantum dots, and thus improve the light absorption of the whole device. Moreover, the electron transport dynamics indicated that the phase junctions between the rutile trunks and anatase nanosheets could accelerate the electron transport in the QDSSCs. As a result, we got a conversion efficiency of ∼2.4% with the thickness of less than 2 μm, which was 50% higher than that in the nanorod array-based QDSSCs.