1 April 2015 in International Journal of Impact Engineering
30 April 2017 in Journal of Engineering and Technological Sciences
INIgnatius Pulung Nurprasetio
Ignatius Pulung Nurprasetio
Macro Data Analysis of Traffic Accidents in Indonesia
1 March 2018 in Thin-Walled Structures
1 August 2018 in Thin-Walled Structures
3 September 2013 in Applied Mechanics and Materials
Numerical and experimental study of the effects of center holes located at opposite sides on dynamic axial crushing of thin-walled square aluminum extrusions column are presented in this paper. The results showed that, by inserting the holes, the impact energy absorption characteristic in a progressive buckling can be improved as the starting location of the plastic deformation is always from holes and peak crush force can be decrease, so that the deceleration does not exceed the limit that can injure the passenger when frontal impact occurs. Here, the results of numerical simulations, conducted using an explicit finite element code, are compared with experimental results for various hole diameter. The results shows that the peak crushing force is decrease, while the mean crushing force is relatively constant.
31 October 2014 in Applied Mechanics and Materials
Numerical study of the effect of spot weld pitch with respect to top-hat crash box crushing characteristics are presented in this paper. Belytschko-Lin-Tsay shell element was used for modeled columns wall with Piecewise Linear Plasticity material model. The impactor was modeled using hexahedral solid elements and assumed as a rigid body. Spot weld joints used to connect mild steel St37 plates of the columns were modeled using beam element and solid element. Impact characteristics related to the spot weld pitch and models were evaluated from simulation results in the form of crushing force vs axial deformation of the column. The results show that spot weld pitch does not significantly affect the crushing characteristics for top-hat crash box with beam element spot weld model, while solid element spot weld model show otherwise. The difference between beam element spot weld model and solid element spot weld model is larger at spot weld pitch 0.50H – H, and tend to close at higher spot weld pitch. Top-hat crash box model becomes stiffer with solid element applied as spot weld model.