Dark current characteristics of germanium (Ge) vertical p-i-n photodetectors were studied. Ge photodetectors were demonstrated on the germanium-on-insulator (GOI) platforms realized via direct wafer bonding and layer transfer. GOI platforms with two different threading dislocation densities (TDDs) of 3.2 × 106 cm−2 (low TDD) and 5.2 × 108 cm−2 (high TDD) were varied via furnace annealing in oxygen ambient. An ultra-low dark current density of 1.12 mA/cm2 for epi-Ge photodetectors was obtained for a low TDD Ge photodetector. This is reduced by a factor of 53 in comparison with a high TDD Ge photodetector. A dominant leakage contribution component shifts from bulk leakage to surface leakage as TDD decreases to 3.2 × 106 cm−2, suggesting that advanced surface passivation is required to further reduce the leakage current. Through an activation energy study, it is revealed that a primary bulk leakage mechanism shifts from Shockley–Read–Hall (SRH) leakage to diffusion leakage in a temperature range of 323–353 K. The surface leakage performed with plasma enhanced chemical vapor deposition-deposited SiO2 is governed by SRH and trap-assisted tunneling leakage processes. Two orders of magnitude enhancement in the effective carrier lifetime is observed with the reduction in TDD. This work suggests that bulk leakage current density and effective lifetime analysis provide a better understanding of TDD-dependent dark leakage current study.
Metal-semiconductor-metal photodetectors (MSM PDs) are effective for monolithic integration with other optical components of the photonic circuits because of the planar fabrication technique. In this article, we present the design, growth, and characterization of GeSn MSM PDs that are suitable for photonic integrated circuits. The introduction of 4% Sn in the GeSn active region also reduces the direct bandgap and shows a redshift in the optical responsivity spectra, which can extend up to 1800 nm wavelength, which means it can cover the entire telecommunication bands. The spectral responsivity increases with an increase in bias voltage caused by the high electric field, which enhances the carrier generation rate and the carrier collection efficiency. Therefore, the GeSn MSM PDs can be a suitable device for a wide range of short-wave infrared (SWIR) applications.
Two novel resonant-cavity-enhanced (RCE) GeSn single-photon avalanche photodiode (SPAD) detectors are designed and simulated for high-efficiency single-photon detection at 1550 and 2000 nm wavelength at room temperature for sensing and optical quantum applications. The RCE GeSn SPAD consists of a PIPIN GeSn/Si heterostructures embedded in an optical cavity formed by a distributed Bragg reflector (DBR) and GeSn surface. The results show that high photon absorption efficiency and avalanche triggering probabilities can be achieved by careful design of DBR reflectors, GeSn absorber, doping concentrations of Si charge sheet layer and multiplication layer, which lead to a high single-photon detection efficiency (SPDE) of ~80%, which is promising for emerging quantum applications demanding high SPDE, such as linear optical quantum computing. The noise equivalent power (NEP) and dark count rate (DCR) as a function of threading dislocations density (TDD) are examined as well. It is found that the device could operate near room temperature with a similar DCR level to that of Ge SPAD operating at low temperature. A NEP of $\sim 3\times 10^{-15}$ W/Hz $^{1/2}$ is observed from RCE GeSn SPAD for 1550 nm wavelength at room temperature. This work shows that the proposed RCE GeSn SPADs are promising candidates for high-efficiency single-photon detection in short-wave infrared (SWIR) regime for sensing and optical quantum applications.
11 May 2021 in IEEE Journal of Selected Topics in Quantum Electronics
Recently, high-performance GeSn photodiodes (PDs) with external light illuminated on the device's top surface have been demonstrated on various platforms. However, for image sensing systems with a focal-plane array (FPA), the front-illuminated sensors usually suffer from area limitations. Here, we report high-performance back-illuminated Ge 0.92 Sn 0.08 /Ge multiple-quantum-well (MQW) p-i-n PD on 300-mm silicon substrate, which was realized entirely by complementary metal-oxide-semiconductor (CMOS) compatible processes. A broadband photoresponse between 1,000-2,100 nm was observed, and the responsivity is 0.2850 and 0.0085A/W at 1,550 and 2,000 nm, respectively. A specific detectivity larger than 10 9 cm·Hz 1/2 /W was achieved between 1,050 and 1,900 nm, covering all the conventional telecommunication bands (O to U band). Furthermore, the influence of the anti-reflective layers also was studied in detail. The result shows the black Si (b-Si) surface enhances more photocurrent between 1,000-1,500 nm while the SiO 2 layer (400-nm-thickness) increases more current beyond 1,500 nm. The 3-dB bandwidth was calculated to be up to 8 GHz for a mesa with a diameter of 20 μm at −2 V. Our experiments demonstrated the high-detectivity and high-speed back-illuminated GeSn/Ge MQW PD with the potential applications in image sensing systems operated in the short-wave infrared (SWIR) range.
Semiconductor nanomembranes (NMs) have emerged as an attractive nanomaterial for advanced electronic and photonic devices with attractive features such as transferability and flexibility, enabling heterogeneous integration of multi-functional components. Here, we demonstrate transferable single-layer GeSn NM resonant-cavity-enhanced photodetectors for 2 μm optical communication and multi-spectral short-wave infrared sensing/imaging applications. The single-layer strain-free GeSn NMs with an Sn concentration of 10% are released from a high-quality GeSn-on-insulator (GSOI) substrate with the defective interface regions removed. By transferring the GeSn NMs onto a predesigned distribution Bragg reflector (DBR)/Si substrate, a vertical microcavity is integrated into the device to enhance the light–matter interaction in the GeSn NM. With the integrated cavity and high-quality single-layer GeSn NM, a record responsivity of 0.51 A W−1 at 2 μm wavelength at room temperature is obtained, which is more than two orders of magnitude higher than the reported values of the multiple-layer GeSn membrane photodetectors without cavities. The potential of the device for multi-spectral photodetection is demonstrated by tuning the responsivity spectrum with different NM thicknesses. Theoretical simulations are utilized to analyze and verify the mechanisms of responsivity enhancement. The approach can be applied to other GeSn-NM-based active devices, such as electro-absorption modulators or light emitters, presenting a new pathway towards heterogeneous group-IV photonic integrated circuits with miniaturized devices.