13 April 2026 in IEEE Access
Electric vehicles for off-road agricultural applications utilize induction motors due to their low cost, simplicity, and efficiency of widely developed control methods, but with challenges in the presence of external factors such as roads with irregularities or internal factors like variations in motor parameters. Given the necessity for robust electric vehicles capable of operating reliably in agricultural environments this paper proposes a robust finite control set (FCS) with sliding mode control (SMC) with PI for predictive current control of induction motor and its application in agricultural electrical traction. The cost function sums the predicted voltages in the stator reference frame from the motor with the robust control voltages and compares them with the voltages of the converter to maintain the proposed system’s current reference. The proposed robust FCS-SMC will be compared to the classical finite control set and robust finite control set using the deadbeat approach. Considering that there are several more complex robust controls, our work focuses on the advantages that sliding mode offers, such as ease of implementation in addition to being a novelty in the literature of the use of sliding mode control with finite control set theory in stationary frame for current control. Experimental tests were developed to evaluate the proposed control, the results show the alpha current component within an adequate operating range, the parametric mismatch test with total harmonic distorsion under 4.1%, the mechanical speed test within acceptable values with low error and computational burden of 61% validates the proposed system.
1 January 2026 in IEEE Open Journal of Power Electronics
1 January 2026 in IEEE Access
5 May 2026 in IEEE Open Journal of Power Electronics
Predictive control has been considered a suitable alternative for controlling electrical machines. This paper presents a predictive torque control (PTC) strategy that integrates the load angle into the control framework for three-phase induction motors. The predicted stator voltage components are obtained from the stator flux deviations and the estimated load angle (LA), which is computed from the slip speed derived from the torque error, and utilizes a voltage-based cost function, eliminating the need for weighting factor while achieving steady-state performance comparable to PTC schemes. The proposed approach minimises computational burden to 44.6% unlike PTC, and also was compared to the predictive current control (PCC). Experimental results at 1345 rpm and 60% load demonstrate that the proposed PTC-LA achieves a 19.44% torque ripple and steady-state speed error of 4.3 rpm, outperforming both conventional PTC and PCC. Under parameter mismatch conditions at low speed, the PTC-LA maintained a speed error below 5.9 rpm and a torque under 0.28 Nm. Furthermore, the proposed control exhibited superior dynamic performance, characterized by reduced settling times and enhanced robustness against inductance variations in terms of torque error, compared to PCC.