Cr(VI) is a known toxic and non-biodegradable pollutant that results from multiple industrial processes, and can cause significant environmental damage if it is not removed from wastewater. However, it can be reduced to Cr(III), which is less toxic and can be readily precipitated out and removed. Here, a fast and facile single-step technique is reported for the synthesis of nitrogen–phosphorus doped fluorescent carbon dots (NP-CD) using a domestic microwave, as a potential photocatalytic material. Under natural sunlight, a simple photocatalytic experiment reveals that the NP-CD are highly efficient for the quantitative reduction of Cr(VI) to Cr(III) in synthetic contaminated water, in a linear range from 10 ppm (in approximately 10 min) to 2000 ppm (in approximately 320 min) by increasing the sunlight irradiation time followed by its removal by precipitation. NP-CD exhibit high recyclability of up to six cycles without any apparent loss in photocatalytic activity, demonstrating NP-CD as a potential photocatalyst material for Cr(VI) water treatment.
The present finding deals with a simple and low-cost fabrication of surface-passivated, brightly fluorescent zinc-oxide-decorated, red-emitting excitation-independent ultrafluorescent CDs, denoted as “CZnO-Dots”. Surface doping of zinc oxide significantly improved the quantum yield by up to ∼72%, and these brightly fluorescent red-emitting CZnO-Dots have been employed for the aqueous-phase photoreduction of 100 ppm hexavalent chromium(VI) to trivalent chromium(III) under the influence of sunlight irradiation. The overall utility of the prepared CZnO-Dots can be ascertained by their recyclability over seven cycles.
The present finding describes an efficient facile approach for the fabrication of nitrogen-doped carbon dots (N-CDs) as a “fluorescent nanoswitch”. Highly fluorescent blue-light-emitting N-CDs have been synthesized via a simpler hydrothermal method using 2,2′-(ethylenedioxy)-bis(ethylamine) and malic acid as the precursors. N-CDs showed excitation-dependent and pH-independent emission along with a quantum yield of ∼25%. The blue fluorescent emission of N-CDs has been selectively “turned off” (quenching of fluorescence (FL)) during the sensing of Cr(VI) with 0.02 μM limit of detection and further been selectively “turned on” (restoration of FL) on sensing ascorbic acid, compared with other metal cations and biomolecules tested. For testing the practical applicability of N-CDs, the switchable reversibility of the fluorescent nanoswitch has been tested for up to four cycles on the basis of FL “on–off–on”. Furthermore, the toxicological test showed the antibacterial effect of the N-CDs on the tested Gram-positive Staphylococcus aureus and Gram-negative Escherichia coli cells. Additionally, these N-CDs can also be used as a fluorescent ink for imaging purposes.
Presently, the doping of carbon dots (CD) with heteroatoms and metal-salts as external dopant is a common practice for enhancing its optical efficiency. This approach can involves the use of biomaterials such as plant leaves since they already possess metals inside as an essential element. In this study, the simple process of carbonization of a leaf extract yielded red-emitting magnesium–nitrogen embedded (self-doped) CD, which were denoted as r-Mg–N-CD, possessing a quantum yield value of ∼41%. Importantly, r-Mg–N-CD was proven to be a biocompatible probe based on the bacteriological test performed on two different bacterial strains, Escherichia coli (E. coli) and Proteus vulgaris (P. vulgaris). In addition to the conventional imaging application, r-Mg–N-CD could also be used for the fluorescence-based selective sensing of Cu(II) metal ions among various heavy metals with a detection limit as low as 50 nM and as red-emitting fluorescent ink.