The packing material selection for a bioreactor is an important factor to consider, since the characteristics of this material can directly affect the performance of the bioprocess, as well as the investment costs. Different types of low cost packing materials were studied in columns to reduce the initial and operational costs of biogas biodesulfurization. The most prominent (PVC pieces from construction pipes) was applied in a bench-scale biotrickling filter to remove the H2S of the biogas from a real sewage treatment plant in Brazil, responsible for 90 thousand inhabitants. At the optimal experimental condition, the reactor presented a Removal Efficiency (RE) of up to 95.72% and Elimination Capacity (EC) of 98 gS·m−3·h−1, similar to open pore polyurethane foam, the traditional material widely used for H2S removal. These results demonstrated the high potential of application of this packing material in a full scale considering the robustness of the system filled with this support, even when submitted to high sulfide concentration, fluctuations in H2S content in biogas, and temperature variations.
1 June 2018 in Journal of Environmental Management
Recent developments in wastewater treatment have led to a renewed interest to obtain elemental sulphur (S°) as a by-product from bioreactors. However, practical studies are limited by the gap of adequate analytical techniques for its determination. This paper provides a statistical study and matrix effect evaluation of an adapted spectrophotometric method for routine S° analyses in aqueous samples, based on a methodology previously described by Hart (1961). Four complex matrices were tested: domestic sewage and effluent samples from three different bioreactors. Tested performance criteria included linearity, matrix effect, limit of detection and quantification and S° recovery. Results were linear (R2 = 0.99994) in the studied range (5 to 100 mg S° L−1) and no matrix effect was observed. The accuracy was based on recovery values that varied from 100% to 106%. The colloidal S° separation and extraction protocol was also considered suitable for aqueous samples, reaching more than 99.0% of S° recovery.